Turtleback Belt Clip Case Made for Applie iPhone 6 Plus (5.5 in.) Black Holster Nylon Pouch with Heavy Duty Rotating Belt Clip Horizontal Made in USA

I love the holster except for the belt clip. The belt clip is made so that you can swivel the holster a partial turn and lift the holster out of the clip then put the holster back into the clip and swivel to lock in. Don't try using the swivel to remove from your belt just pull the whole clip off your belt, It worked a couple times then the shaft on the back of the holster starts to turn and you can't get it to latch back into the clip. I had to bend the receiving section so that I could get back together without it just lifting back out of the swivel bracket. This is hard to describe what I mean, just suffice to say don't use the swivel to remove the holster from your belt, remove the whole clip to take the holster off your belt. You can still use the swivel to position the phone at whatever angle you like.Other than the issue with the swivel, I really like the holster. The phone slides into the holster even with a protective case on the phone (I use a case-mate). The case on my old android was an otter box which makes your phone almost indestructible but it made it difficult to get in and out of my car) it would always get in the way of the steering wheel. My old android had a much smaller screen but was still more difficult when getting out of my car. Since this holster works best in the vertical position and is not as fat as the otter box, it does not cause such a problem getting out of my car even though the screen is a full inch bigger on this phone.It is a snug fit for the phone with it's protective case on but is easily removed and inserted when facing the screen towards your body. If you slide the phone into the holster with the screen facing away from you, it is very difficult to insert and remove the phone.Yes the case isn't leather (but that doesn't matter to me) and you can catch the top of the cover on something and it will open on top, but the phone won't fall out and the magnet is strong enough to keep it closed or reclose on its own.The phone holster works very well for me and other than the issue with the swivel clip which does swivel to reposition the phone at a different angle just don't use it to lift the holster out of the belt clip.I like having my phone on my belt so that I can easily carry it around and access the phone. This holster works quite well for me.If you want a belt holster for your "iPhone 6 plus" buy this holster and I think you will be very happy.

Update to 4 stars: The company replaced the case with a new one. While you can tell where the belt clip is from the inside, it no longer has ridges that give me worry. My iPhone is now riding screen-in, as it should be. :-)--I bought this case to fit my iPhone 6 Plus. It fits it well, and I have no concerns about the phone slipping out or accessing the phone. I have a thin, i-Blason case on the phone, and it still fits all right. A bit tight top-to-bottom, but the holster is relaxing as I use it.However, I am concerned about putting my phone in the holster screen side in. The holster has two sides to it, the side that has the belt clip and the side that the flap folds down onto. Both sides are soft leather, but the belt clip side is not smooth. As I run my fingers along the inside, I feel ridges where the belt clip attaches to the holster. And the top of the belt clip can be felt as prominent bumps. I can feel the entire length of the belt clip from the inside of the holster. When I place my phone into the holster, these bumps press against the screen about 1/3 and 2/3 of the way up. I'm concerned that, over the months as my phone is pressed against these bumps, it will cause uneven screen wear. Because of this, I'm putting my phone into the holster screen side out so that the back of the case is against these ridges. This is not my preferred way to store my phone, as it makes it difficult to get to the mute switch. But it's the only way I feel safe storing my phone.I've attached a picture of the ridges. My finger is pointing to one of the bumps on the inside of the belt clip side.(I'm considering trying to make a felt-covered plate to hot glue into the holster on the belt clip side to mitigate this problem.)

Let me stress that despite the noted concerns, I have used (and continue to use!) this case for over three years now. That's a pretty impressive track record. However...There are two issues of which a potential buyer should be aware. The more serious one is that eventually the magnets that secure the flap come unattached. I tried a small slit in the inside fabric and hot glue, but that fix didn't last. I eventually just removed the magnets and moved on.The second is that the belt clip tends to distort slightly. Once this happens, the case can slide out of the clip without being completely upside down. Sitting in the car the phone would slide up and end up between the door and the seat. Simply squeeezing the clip back into shape with a pair of water pump pliers (the kind with big jaws and long handles that let you apply a lot of pressure) about once every six to twelve months solves the problem.The case was originally used for a Pixel XL in a very thin case with tempered glass screen protector and it fit fine. It now is a home to my Pixel 3 XL in the same style of case and continues to fit fine.Were it not for the magnet issue, this would definitely be a five-star product. Anything that I can hang from my belt every day for more than three years is well made.

Swivel not very functional and extremely hard to get on belt.

well made felt like I was carrying a gun

very good but clip needs to be have much more tension - slips off belt

A quality product with a nice tight clip and suede like lining. I would prefer it has a couple belt loops on the back as added security. Im confident it will last at lease 4 times longer than my $20 belt case. A good value when you look at it that way.

A robust case with excellent quality. Clip is all metal and very solid. Strong double magnets keeps phone securely in case. Case rotates easily, so gets out of the way when seated in car. Although case is large, as would be expected for the iPhone 6 Plus, you don't even know it's there when clipped to your belt. iPhone with SpiGen clear case fits in perfectly. Definitely a better alternative to putting your beastly iPhone 6 Plus in your pocket!! Second time I have purchased this same case. First one lasted almost 4 years with daily use!