Casaverde 4.5Inch Super Thin Diamond Tile Blade for Cutting Porcelain Tiles Marbles

Very clean cut on porcelain tiles. Had a small project to complete and this disc cut the tiles with little to no chip out.

Great blade! Put it in my little plastic table wet saw and moved right through the tiles. Was working with small two inch octagon sheet tiles and was nervous about having my fingers so close to the blade. No problem, didn’t chatter at all, just nice and steady.

Works amazing! I am cutting 47” long porcelain tile with this blade. I needed a blade to make nice finish edges lengthwise. (See pics) I’ve never seen a wet saw big enough for 4’ tile, so I had to use my Bosch 4.5” angle grinder. I bought three different blades and this one worked the best, by far. Fast and leaves a nice edge. Not perfect, but that is impossible with an angle grinder. Even a wet saw leaves some imperfections. I did not expect to be able to ‘rip’ porcelain tile and get such a nice finished edge. I can’t recommend this blade high enough, especially for the price. It is worth 5 times as much for the quality of the cut. Tape your cut line, back cut from the far end about an inch first, then use a steady hand, or two...and go slow in the last inch. Also, very important to support the entire tile on a board or sturdy cardboard box/sheet. I used a cardboard box so I could cut deep and use the front edge of the blade cutting as close to vertical as possible....in other words, the blade was as far into (below) the tile as I was cutting...cutting through the cardboard. One more thing. If you are cutting a notch, like in two of the pics, crosscut the short side first. Good luck.

I literally abused the heck out of this wheel. I’ve cut several pieces of tile for a bathroom and ground some in to specific shapes and contours. I also ground down some epoxy resin on a concrete floor to feather the transition. I’m sure this wheel isn’t designed for most of what I used it on but it did the job. It’s definitely smaller and has wear but will still cut. I feel it’s held up very wheel for the hours of grinding/cutting I’ve done with it.

I made two bathroom countertops using porcelain tile. Cut large 24x48 tiles using a Ryobi tile saw including all back splashes and edge tiles. The blade cut through them like butter. I took a lot of precautions to support the tile while cutting. Not a single tile broke. I could even cut off a 1/4 in strip without breaking. Minor edge chipping less than 1/32 was expected with porcelain, which can be further reduced by pre-scoring along the cutting edge. The blade seems to have a lot of life left. Would definitely buy again.

This blade is awesome and priced well. It fits a Roberts undercut saw. It cuts through stone, brick and mortar with no problem.

ok

Remodeled a bathroom and worked with 12 x 24 tile. I had to cut in a couple of outlets. How else are you going to do that? I had a pro do some tile work here once, and he used his grinder for all sorts of stuff, which is what gave me the idea. It's cheap and it gets the job done. If you need to cut a chunk out of a large tile, or mod something right at the wall where you're going to put it, this is the way to go. When you're done, you can take this blade off of your grinder, and it's a regular tool again. I would recommend this to anyone. It works.

I bought this blade when in a pinch. I was cutting ultra compact surfaces (dekton etc). I dropped my blade on the ground and bent it. Ordered this blade and to my surprise, it cuts better than my very expensive blade that’s specific to ultra compact material!! I bought 10 more to keep in stock since I use these a lot! Great product!

Had to drill arbor out to 1". Works well

El corte es lento pero queda muy limpio sin descosían el porcelanato

Buen producto .

Excellent, cuts amazing. Save so much time.