Orbit67030 Drip Irrigation 2-Port Full-Flow Manifold

Super easy install, and putting the drip hose onto the manifold was a breeze.

I needed an extension to reach another part of the plant with this piece I was able to do it. I will be ordering more for my other plants

Works perfectly for my system, connecting two 1/4-inch ID irrigation lines to my watering circuit. The 1/4-inch irrigation line ports (barbs) hold my irrigation lines securely. There are no leaks even with full home water pressure and most irrigation bubblers on those lines turned off.However, I take one star off for a design flaw that caused me to change the way I installed the part. I did not use the enclosed gasket/filter basket. Two reasons: First, my system is already protected by a filter upstream (before the irrigation timer), so I didn't need redundant protection in this connection. More importantly, quick inspection reveals the enclosed cage if installed would be resting directly on the tiny tabs that retain the 1/4-inch ports in place. If you tighten everything down, it seems obvious the pipe being screwed into the cage/gasket would put a lot of force on the back of those ports -- in effect trying to push them out from the back out of the housing. (The tabs holding those ports in place are only plastic and they are small -- almost certainly the weakest part of the overall structure.) I imagine this is the cause of some leaks and breaks reported in other reviews. Instead of using the gasket/basket, I left it out and used PFTE plumber's tape to seal the fitting threads; then I did not need to tighten the pipes down so hard that the connector put pressure on the back of the ports. As installed (minus basket, plus PFTE tape), the ports are firmly in place, everything works well, and no leaks.I will write back to update this review if any problems develop in the next year, but I believe that avoiding use of a gasket seal and instead using plumber's tape likely eliminated the mechanical torque on the internal components that could otherwise cause premature failure.

This tool makes directing the flow of water to pots to make sure they are getting enough water. Easy to install.

This fits the 1/2” treaded pipe where my sprinkler is connected and it works either 1 or both sides.

Great Way to connect drip lines!!!

I wanted to convert one of my needed irrigation heads to 1/4 inch tubing to water flowers in pots on my deck. Works exactly as I needed them to.

they work, but as they're for outside, and exposed to UV rays, the plastic gets hard and brittle and the two elbows often break off after a year or two. I wish it came with a few replacement elbows so I wouldn't have to waste plastic and keep buying the whole part.