Phobya 3-Pin x 4 Fan Cable Splitter (Black)

this thing works really well. it's long enough, well sleeved, and works every bit as advertised. you have to make sure do some research before plugging more than two fans using this thing to one single header. some motherboards only supply total of 6 watts, some 12 watts, some more to each single header. find out how much power draw your fan produces, the last thing you want to do is overload your header and causing some terrible mishap. most mobo should power at least two fans through a single header, unless you have some extremely efficient fan that draws 6 watts each. also some fans have a higher startup power draw that levels off after it starts spinning, so factor that in as well. email your mobo manufacture, they'll tell you.

Overall a very good quality braided cable that's all black with no mustard and ketchup cables. The only thing is give as feedback to seller is how about different colors like red, blue, or purple. I like the length, not too shirt but also not long enough to cause issues with cable management

Needed a couple of these to connect the 12 fans in my CaseLabs tower. The cable length was plenty long enough to connect everything. Nice product, thanks..

I would have loved it, if I had gotten the right thing. I ordered the splitter hoping for what the page says it is, yet I received a 1 3-pin to 1 3-pin + 5 2-pin fan splitter. Not sure why I got the wrong thing, and I am not willing to fix the issue. I just ended up buying 3x 1 3-pin to 2 3-pin splitters that are made by my case manufacturer.

Nice and clean cable wrapping. Did exactly what I needed and supplied power to 3 pre-installed case fans I had in my case. No problems as of yet.

3 of the connectors were missing a pin, the other one had bent pins. Terrible quality control.

This splitter is a 3-pin to 4x 3-pin breakout splitter. Good quality and good sleeving on the cables themselves. My only complaint about the sleeving was that the heat shrinked region where it initially breaks into 4 wires is a tad rigid/thick, making it an extra consideration when doing cable routing.These are set up so that the RPM/tacho wire is only present of one of the 4 split fan ports, allowing one to connect 4 similar fans to a single header and still get a reasonably accurate speed signal. Would definitely purchase again. I'm using three of these cables to control 4x 140mm Thermaltake Riing fans in push/pull on a 280mm Alphacool UT60, 3x Swiftech Helix 140s on a 420mm rad (push), and the last one controlling the other 3x Swiftech Helix 140s for the pull side of that radiator. All 3 of those cables are then routed to an Aquacomputer Aquaero 6 Pro, which adjusts the fan speeds via direct DC voltage control.Works great. Decent price.

cable length was a lot longer than i was expecting and happens to reach all the fans almost precisely the way i want it to ... no problems with it just make sure you understand how long the cables are ... i'm building in a full tower and had a little extra room in my cable runs with fans both at the top and at the bottom ... if i were using a mini tower i'd have to get plenty creative about hiding the wires for a tidy build