Which skin type is it good for?✔ Normal✔ Oily✔ Combination✔ Dry✔ SensitiveWhat it is:A setting powder that provides 100 percent mineral broad-spectrum UV protection with a flawless, satin finish—perfect for setting your makeup and re-applying SPF in just one step.Solutions for:- Dullness and uneven texture- Fine lines andwrinkles- OilinessIf you want to know more… This silky, super-soft powder goes on smooth and sheer to minimize oil and shine. Formulated with non-drying ingredients, the application leaves you with a soft focus matte finish, blurring the look of fine lines and imperfections. It’s perfect for on-the-go SPF protection and achieving a flawless-looking complexion. With the reimagined formula also comes a broad shade range to ensure every skin tone gets a perfect finish. Meet your match with light, medium, deep, or translucent. - Light: for fair skin tones.- Medium: for medium skin with neutral undertones. - Deep: for deep skin with neutral to warm undertones. - Translucent: for all skin tones.What else you need to know: Right from its beginning, Supergoop! has been incredibly thoughtful in what they put in their formulas. They never use anything that might be considered controversial, including parabens, synthetic fragrances, or oxybenzone. All of their formulas undergo an evaluation on sun protection water resistance (where applicable) and an in-vitro broad-spectrum test in compliance with FDA protocols. They are also 100 percent cruelty-free. Clean at SephoraClean at Sephora is formulated without a list of over 50 ingredients, including sulfates (SLS and SLES), parabens, phthalates, and more. For the full list, check out the Ingredients tab.Suggested Usage:-Remove the cap and slide open the clear plastic sleeve.-Remove and discard the plastic pin at the center of the brush. -Tilt and tap the brush gently against your wrist until you see the powder starts to flow though the bristles.-Use powder generously to reapply your UV protection.How to clean and refill: -Pull brush from magnetic base and wash with a mild soap and lukewarm water.-Unscrew the jar at the bottom of the brush and load the refill by screwing until tight. Precautions:-For external use only.-Do not use on damaged or broken skin.-When using this product, keep out of eyes.-Stop using if rash occurs.-Keep out of reach of children. Ingredients -Mineral Zinc Oxide 24.5%: Delivers broad-spectrum UV protection. -Ceramides and Olive Glycerides: Help seal in moisture. -Coated Silica: Diffuses light and diminishes the appearance of pores, creating a soft focus finish Calcium Aluminum Borosilicate, Silica, Polymethyl Methacrylate, Ethylhexylglycerin, Triethoxycaprylysilane, Nylon-6/12, Sodium Dehydroacetate, Olive Glycerides, Ascorbyl Palmitate, Ceramide 3. May Contain +/- Iron Oxides (CI 77492, 77491, 77499), Titanium Dioxide (CI 77891). Clean at Sephora products are formulated without: Sulfates—SLS + SLES, Parabens, Formaldehydes, Formaldehyde-releasing agents, Phthalates, Mineral Oil, Retinyl Palmitate, Oxybenzone, Coal Tar, Hydroquinone, Triclosan, Triclocarban, Undisclosed synthetic fragrances (Products can be formulated with disclosed synthetic fragrances that meet the following two criteria: (1) the synthetic fragrances do not include any of the ingredients listed in numbers 1 through 12 above and (2) the synthetic fragrances are at a concentration below 1% of the total formula) The following type of acrylates: (ethyl acrylate, ethyl methacrylate, methyl methacrylate, butyl methacrylate, hydroxypropyl methacrylate, tetrahydrofurfuryl methacrylate, trimethylolpropane trimethacrylate , aluminum salts), Animal Oils/Musks/Fats, Benzophenone + Related Compounds, Butoxyethanol, Carbon Black, Lead/Lead Acetate, Methyl Cellosolve + Methoxyethanol, Methylchloroisothiazolinone & Methylisothiazolinone, Mercury + Mercury Compounds (Thimerisol), Insoluble Plastic Microbeads (This prohibited ingredient applies to products that are meant to be rinsed off ), Resorcinol, Talc (Talc that is free of any asbestos can be used in the formulation provided that Brand conducts testing to ensure that talc is free of any asbestos.), Toluene, Butylated hydroxyanisole (BHA), Butylated hydroxytoluene (BHT) that is 0.1% or more of total formula, Ethanolamines DEA/TEA/MEA/ETA, Nanoparticles as defined by the European Commission, Petrolatum and Parrafin that is not USP grade, Phenoxyethanol that is 1% or more of total formulation, Polyacrylamide & Acrylamide, The following types of Styrene (Bromostyrene, Deastyrene/acrylates/dvbcopolymer, sodium styrene/divinylbenzene copolymer, styrene oxide, styrene), 1,4 Dioxane in final formulas must comply with the thresholds as follows: (10 or < ppm for products that are meant to be rinsed off, wiped off or removed, 3ppm or < for products that are meant to remain on the skin).
Trustpilot
Hace 2 semanas
Hace 1 día
