LICHIFIT 4100E 2.4G 4-Channel 4 Channels Micro Receiver for JR/SPEKTRUM DSM2 Transmitter

Works well for light build planes. Perfect for spektrum. Easy to bind.

Bound to my Spektrum NX6 transmitter no problem. Using it in a home built Great Planes airplane. As others mentioned there was no documentation but just followed the instructions that other reviewers have posted. I will buy it again in my next plane.

I can’t get it to bind with my Radio Master Pocket with the RM4in1 module! Any suggestions? I was under the impression it would.

Bound easily to Spektrum DX6e.Pinout is attached in photo.Input Voltage Range: 3.6-10vModulation: DSM2 /DSMX-------------------------------BINDING iNSTRUCTIONS:-------------------------------1. Put the binding harness into the Channel marked BIND. Next apply power to the receiver. Receiver’s LED should illuminate.2. To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested). Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter.3. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid. All fail-safes should be programed correctly now.4. Remove binding harness from the BIND channel. Restart the receiver by cycling it power off and turn on. All channels should function properly now. You may test fail-safe by holding sticks in corner, cycle transmitter on and off. Surfaces and throttle should return to your preset fail-safe positions.

I was building a Flite Test plane that would be less than 250 grams. I needed a receiver that would work with my Spektrum transmitter and 5 gram servos. This does the job. I suspect that it will have a very short range but I’ll be keeping the little plane close to me.

I had no issues binding this with my Turnigy 9XR pro with orange ORX transmitter module. As noted there are no instructions or markings . Just follow the images found on other users review. Easy

As others have noted, there’s no documentation included. The negative pins are furthest from the board. If connected incorrectly, the LED just “blips”, connected correctly, the LED stays on. Bound to my very old Dx6i with no problem.

I purchased this receiver because it should have worked with my old spectrum DX3C transmitter that is DSM2. I tried to use it for a 1/24th scale LCG micro rock crawler build. It's a good size for 1/24th scale if it would work. It will bind to the spectrum DX3C transmitter no problem but no control functions. It seems like a hit or miss on this one. Seems to work great for some people and not for others. There's not much literature on this receiver but it seems pretty basic.

This reciever is lightweight and provides good range. Basic without bells or whistles which is exactly what I needed.

je l'utilise sur un bateau remorqueur a l'echelle et fonctionne tres bien avec ma spektrum dx9

It binds fine until you change the battery. So you can bind it, remove the bind plug and then fly. When you unplug the battery, it forgets and needs to be bound again to get a solid light.

For spectrym