SeaSense Recessed Cup Holder

This product was listed as 3x3, but is not. The inner diameter is approximately 2-3/4" and is under 2-7/8" outer diameter. I guess they are saying you should cut a 3" hole but even that is not a great excuse for saying it is 3" in diameter. The material and design seem good. My only complaint is the incorrect sizing information. Getting accurate size information is very important before making a purchase and i'm annoyed I have to go through the return process because they seemed to think ball-parking the estimate of the diameter was alright. Additionally, this size does NOT reasonably accommodate a can with even the thinnest coozie. A cup holder that is actually 3" in diameter would.

I cannot complain about this product. It was a perfect replacement for the one that blew out of my boat. I found the exact same one for about half price at Walmart a few days after I had already ordered one.

This is a very basic thing and just what I needed to make a bedside cup holder for my Mom. The quality is good. I purchased a small plastic cutting board, drilled a hole in it for the recessed cup then slid it between the mattress and boxspring. Keeps her water bottle handy.

I planned on installing this in my kayak but it doesn't fit a can with a can koozie on it. Not sure what I will do with it now.

Exactly as pictured. Used as replacement for couch cup holder, and while not identical it's very close.Also used on an outdoor bench that I cut holes in to hold beverages

I bought 2 of the 3.25" cup holders to go on my Jon Boat. They are made of a pretty solid plastic, has drain holes on the bottom. Will hold a 12oz canned beverage in rough water, in some cases better than you can at the time. And still big enough to hold a large cup from your typical fast food restaurant. Well worth the money.

Great value. Cans and smaller cups fit perfectly. Not made for wide cups.

work great

This holder doesn't sit firmly in my car's cup holder - I had to add some double sided tape around the outside to make it sit firm enough that I could put a large bottle in there. Once I did that, it worked fine for holding 1 litre bottles of pop, but doesn't work well for smaller bottles at all, they just flop around. For the price, I'm satisfied.

fits perfectly on my seadoo sportster boat. My previous one were white and I bought this black and boy they looks perfect! The size is true as what's described. I will dfinitely buy again for some replacement in the future.

This is a stepped cup holder, I thought going by the picture that is was not stepped, otherwise I would not have bought it. Hold a can of pop nice, but a bottle of water, pop or similar it does not sit nice and flops around.

Great replacement cup holder!

PERFECT FIT

It's OK but smaller than I expected. It has tiny drain holes in the bottom that is not in the description.

Worked well for what I was using it for , but I feel it was over priced

Bought it as a gift and with the screws attached, it will work great.

Fit perfect in my boat

It's a cup holder. Nothing complicated about it. It does the job.

good but is 2.75 in.

what can you say it got here

As advertised

Solid cup holder does the job.

Yes this worked great for the console we built for our RV!