BenlariChrome 1 Inch Motorcycle Hand Grips Handlebar Grips Cable Throttle Compatible for Harley Davidson Sportster Touring Dyna Softail Street Glide 883 1200

I like the grips, to bad they won't fit! The groove,where it fits into the clamp,is to large in diameter! Grip diameter is 29 mm OD and the clamp, ID 27mm! I should have taken the time to measure before purchasing!

These are ok as far as fitting over the handle bar. But too large to fit into the cable housing. I had to do alot of trial and error filing. Even though it is working. The throttle hangs up. Horrible product.

Fits HD 99 sportsterI added three lock to the left side grid on the holding screw so that they don’t vibrate offMy old ones rubber was coming off as you can see in the picture.They feel like light weight material so I don’t know how well they will last. Only time will tell.

I really liked these grips felt nice and install was easy about a week after install the end piece of the left grip fell off somehere going down the road. Hopefully can get a replacement

This says it’s compatible with Softails from 1996-2018 but the holes for the ferrels are definitely too small for my 2010 softail. It is easy to fix with a drill and some sandpaper to clean it up after drilling it out but annoying none the less. I guess at $15 what else can you expect though. The other thing I don’t like is that on the clutch side the grip is held in place with 2 set screws, which I am worried about scratching my new bars so I ran some electrical tape around the inside of the grip at that spot to soften it a little. All of that being said they look really nice and the knurled grips are nice. At the price they are great.

Love my grips

These were very inexpensive, but performed and installed in minutes. I would definitely recommend this product and site

The left side grip does not fit a Harley Davidson Motorcycle! it is supposed to be held secure inside the housing! this does not, instead tiny screws hold it on and it does not fit all the way onto the bars, due to not being able to be fitted inside the housing! no way you would trust to ride with them! halfway off the bar and tiny screws holding it half way on!