15-Bin Garage Organization Rack - Carbon Steel Rack with Removable Stackable Plastic Garage Storage Bins - Tools Organizer or Small Parts Organizer for Hardware,

I put my unit together in about 45 minutes. The instruction page (only 1 page, a single sketch of the assembly) is very minimal. All pieces were included and none of the bins were damaged. All intact. The bottom shelf had a small surface marring, likely due to shipping jolts. At first, I thought that 3 of the horizontal backing shelf brackets were missing, but after some hunting, I found them tucked inside the top shelf cover-piece for shipping. Panic averted.The hardware bag had 3 sets of machine screws. There were spare extras included in all three bags. The LONGEST of these (no nuts, no lock-washers) are used to fasten the uprights to the base and the one vertical upright brace to the horizontal shelf racks. Do the upright brace last. The machine screws with LOCK-WASHERS are used to fasten the diagonal foot-braces to the two upright end-pieces. The horizontal shelf racks are fastened to the uprights using one machine screw and nut for each hole.I strongly suggest two things:1) Despite the temptation for speed purposes, don't use a power drill to assemble the screws and nuts. Use fingers, a screwdriver and hand socket wrench. The screws and nuts are finicky to join them together and easily misaligned and/or over-tightened. That will easily strip them, as others have done with power tools.2) Don't tighten ANY of the screws until all of them are in place. Leave them loose. Once they are all joined and properly in place, then you can tighten them all up - by hand.

Lots of use out of these. No problems

First the bad...the directions weren't very clear, and the figure included was missing a few of the bits of hardware. In addition to needing a #2 Phillips screwdriver, you'll also want a 7mm wrench or (preferably) socket to properly tighten the screws/nuts holding the crossbars in place. The lip on the back of the bins seems a little thin, and only time will tell if they hold up. The metal parts have a few imperfections in the paint, but those don't impact assembly or functionality.The good...this turned out to be much sturdier than I was expecting while assembling it. It's heavy (like 40 pounds), which isn't great for moving it around, but it's not going to fall over. The kit includes plenty of extra screws, nuts, and washers. The bins are sturdy (beyond the questionable lip) as well, and have convenient label holders (blank labels not included).All in all, this is a good buy for the price point, and I'll purchase another one if I need additional storage.

could be more sturdy

I like it very much useful

Good

The set seems to be a great deal when you first receive it. The bins themselves are relatively sturdy and a good size for smaller itEms like nails, screws, bolts, etc. The board they hang on, the drywall anchors and the screws used to hang the bins, however, are low quality and not able to complete the job intended.The instructions suggest putting each support in a stud, but the guide holes in the backIng aren’t placed wide enough accommodate that guideline. This leaves the option of drilling holes for dry wall anchors. There’s no information in the provided instructions the size of bit to use for this, so a you’re left starting at the smallest reasonable size and going up till you find a fit. Once done the anchor amounts to a plastic cylinder with three small ridges that protrude out to hold onto the dry wall. These ridges just serve as effective means to mill the surrounding Sheetrock into dust as you attempt to tighten down the screws And the anchor spins with it.The screws strip even when hand applied and the backboard cracks of you look at it wrong.

Took me five minutes to get it hung up and put together. It is a great option. If you don’t want to spend money on a fancy unit. The trays are a bit flimsy but definitely hold anything you put into it. Just place it somewhere it won’t get bumped because the trades will come straight off the hangers if you bump them