TORRAMINeoprene Material Rubber Sheet Roll 1/8 (.125) inch T X 4 inch W X 10 Feet, DIY Gaskets for Sealing,Protection, Abrasion, Supports, Leveling, Bumpers

I ordered this to use as a rubber spacer between an aluminum deck plate on the steel framerails of my semi truck, just like the factory does. Aluminum and steel don't mix well and need a spacer to prevent corrosion and this worked perfectly. Exactly as described. Plyable yet strong and doesn't tare but is easily cut with razor knife. The is some smell of rubber, but hey, it's rubber and rubber smells. Comes sealed in air tight package that is pretty tough plastic as I couGld not open it with my hands and had to use a razor knife. Glad I found it as the truck dealers I contacted don't carry this in stock. Will work perfect for my need.

This is a great rubber backing to use on vinyl Chess mats. It not only lessens the thumping sound of pieces landing on the mat, but also keeps the mat from moving accidentally when sliding the pieces. And, although it’s a little stiffer, it is still easy to roll up for storage or travel. It would have been prefect if they made this material in the size of 24” x 24” x 1/16" square, but using this 12” x 48” x 1/16" works as well.After cutting it in half, I attached the two rubber backings to the back of my vinyl Chess mat as shown using Flex Shot Silicone Rubber and a plastic spatula to spread it around evenly. Then, I allowed the rubber sealant to cure for a full 24 hours where I then used an X-Acto knife to trim the excess rubber at the edges of the mat. Clean up is a little bit of work, but produces great results afterward.

I installed this rubber strip on the door that encloses the engine compartment of our rough terrain forklift. It is one of those doors that goes over the engine compartment and lifts from horizontal to vertical in order to access the engine. When closed, there was a 1/2" gap between the door (or hood if you prefer) and the chassis. I used self tapping screws and went through the rubber into the hood and secured it into place. I did this 6 weeks ago and barely a drop of rain gets through now.This is good rubber that is not either too soft nor too hard. It is just the right consistency at 1/8" for the job it was intended. This is a good product and I would buy it again.

I needed strips of rubber to affix registration information onto for my inflatable boat. This stuff worked great for that purpose. It's thick and obviously rubber. I don't THINK it's neoprene though.The rubber roll was extremely dirty (unexpected) and smelled like a tire factory (not unexpected). I had to clean a lot of small debris off of it before affixing registration letters.

Very thick & durable… excellent for my needs! GREAT PRICE & VERY FAST SHIPPING!(SERIOUSLY FAST! NO JIVE!)

I used this to cover the cracks in my chicken coop nesting doors on top. Works perfect. No rain has penetrated the nesting boxes and is holding up great in the sun. very good quality.

I ordered the 12" X 24" roll, I did not measure it to see if it was true dimensions because it was bigger than what I needed.I wanted to use it as a "backer" for a lightweight project that I am working on. I could not get this stuff to lay flat even after using a heat gun on it.If you are putting something heavy on it then you should not have any problems, it is plenty durable.I read reviews complaining of the smell but I did not really notice (perhaps due to other things that were going on in my workshop).If you are wanting something that is for lightweight (less than 2lbs.) projects you should probably look elsewhere or plan on using a very strong adhesive.It is a really good product, just not for this project. I am trying to make a custom mousepad.

SURPRIZED TO ACTUALLY FIND THIS PRODUCT AND AT A REASONABLE PRICE

Great quality and worked excellent for the job I needed it for

Good flexibilty, yet stiff enough.I had to double the thickness using a special glue. That created a strong chemical bond. The material is relatively easy to cut with a sharp blade.

the only think i didn't like with the rubber is the corners curled.

Worked well for what I had to fix with.

Good quality exactly what I needed