TEKTON 3/8 Inch Drive x 7/8 Inch 6-Point Oxygen Sensor Socket | 4929

Socket is very well made and works as attended

Bought this to remove O2 sensors from a 2004 Crown Victoria. Worked perfectly. I like that it has a much smaller wire gap than others I've seen. It makes it sturdier. I still used a hose clamp around it because the O2 sensor was incredibly stuck (270,000 miles) and it worked great. If only I hadn't broken the oil dipstick pull ring off when O2 sensor finally broke loose (bought another one on Amazon). 🤪

I needed this tool to have my o2 sensor changed, and we couldn’t have changed it without it! It’s made to be very durable! It was the perfect size and helped make it easy to remove.

Worked perfectly for my Tundra, glad I purchased,

Perfect fit

Decent quality put A whole lot of crank on O2 sensor to break loose and did not slip or crank.

Good socket

I purchased a generic O2 sensor socket set along with my O2 sensors. When I went to work on the car, the darn crappy sockets slipped. I spent 3 hours spraying penetration fluid, heating, praying, swearing and trying to work the O2 sensor free using the crappy set. I then went on Amazon and purchased this socket along with another style from this brand. As soon as I got it, I noticed a nice strong heavy metal quality to it. The generic ones were a lighter and cheaper alloy. Once I got the hood up, the upstream sensor was out in 15 minutes. For the down stream sensor, I had to use a 26 mm wrench on the head of the socket to take it off. I also used a metal hose clamp around the end to prevent any chance of slippage. Just for reference, I tried using a 22 mm close end wrench, but it wasn't a six pointed, so it slipped. This took me about a half hour as I had little ground clearance. If you're going to change your O2 sensor, I would recommend getting this brand. Save yourself a lot time, aggravation and money. Don't cheap out on the socket like I did.