Moultrie Pro Hunter II Feeder Kit, Black (MFG-13448)

Good feeder motor.

Had to replace the controller for my feeder. Perfect fit and works great.

This 6 volt feeder motor is much better than the original AA battery version. It is much sturdier and has a critter guard that protects against racoon damage. Although setting it is a bit more complicated, it does work well. Just know you must use alkaline batteries (not cheap zinc-carbon batteries) because the cheaper zinc-carbon batteries sold at most stores around town do not have the power to run the motor. The better and more expensive alkaline batteries are not sold in all stores. Because I did not realize batteries were the problem, I actually replaced a good feeder motor thinking it had gone bad. Now I know to only use alkaline batteries. One battery gets me thru the whole deer season.

These are great feeders if you have your own barrel. The quick attach system is great. Makes it simple to remove and store the feeder when not in use. I have switched all mine over to rechargeable batteries since the rechargeable is about the same price as a Duracell. I do not use a solar charger because the raccoons tear them apart.The spinner will get gummed up and corroded where the motor shaft attaches to the spinner plate. If you are leaving it out in the weather year round, let it spin daily even if there is no feed in the barrel, to keep it free. It also helps to spray WD40 on the spinner plate base once in a while.Moultri revised the clock buttons a few years ago. I wish they had not done that. They added a button to the unit that makes it more confusing to set and adjust.

works as it should.

Prompt, Accurate and timely

Worked as advertised, would buy again if needed.

put this out, on a new feeder, about 3 months ago, it worked good for about 2 months. Its is not easy to set up, basically a pain, way too many steps to go through. It started working part time, only throwing corn ever so often, acted like the battery was bad, changed the battery several times, then it would not work at all, tear it apart and reset it, checking to make sure it was working, would use the test button, and it would throw a lot of corn. When hunting the feeder would never go off, tear it apart again, everything was set like it was suppose to be. Then i went and started reading review, and it seems a lot of other people were having, the same problem. So i ordered a different brand, and installed it, and its working great, so as for this brand, it went in the trash can, what a waste of money, do not buy it or you will have the same problem.