YOCTM Compatible with Jeep Grand Cherokee 2011 2012 2013 Gear Shift Cover Interior Accessories Real Carbon Fiber Center Console Cup Holder Cover Trim

Fit over my gear system, but was too large to cover my usb tray on a 2019 Jeep Grand Cherokee Limited X. So I stayed with the gear system only. Still looks good.

I’d consider this brand for other products, the glue works strong than others easy to clean looks good and does the job.

Looks great and sticks well, but fitment isn’t perfect. Can see edges of silver in some spots, and is a little extra noticeable around the gear number/letter squares no matter how you position it, something isn’t perfect

I have a 2015 Jeep Grand Cherokee that is all black inside, minus some “gold” accents that didn’t match at all so I redid the entire inside with these carbon fiber covers. These ones are slightly different from others as they are malleable thick “stickers” instead of hard covers but I understand why. This section in Jeeps have odd curves so a malleable item makes more sense. It did take a little bit of time and finesse to get them to sit as straight as I could get them, and they don’t fully cover the sides, but all in all they look better than what was there previously. If you have patience and a good eye, I do recommend these covers.

The item doesn't really cover the sides which is acceptable to me. My biggest problem is that the item isn't cut evenly. One side is lopsided along with the top near the storage compartment. It doesn't allow it to open. I'd personally pass on this. Would be better to custom wrap or go with another product. The large gaps on the side and the blocking of the storage compartment door leaves a lot to be desired.

Looks nice but doesn't fit very good

This carbon fiber consul is the best i ever bought, i am so happy with it. it is real carbon fiber and very rigid installation is a little difficult because its so sticky once you put it there it sticks, so that makes it hard to go over the shift and line op the cup holders, you cat move it around to line it in place, the answer is spray a little soap and water and spray on the car surface not the carbon fiber this allow the solid piece to allow to slide it around and line all the edges and cup holders in the right place, then just take a plastic small squege to smooth it out and work all the liquid out, its really easy after you get it in place just keep pressing it in place until it all sticks, the soap and water will dry quick so dont worry . you will love the look, it took about 15 minutes from start to finish.Also buy the shift fiber covering, the two match perfect . This is so worth the price and the look is amazing !!!!!!!!

Bien