Flex-Hone Tool-BC17824 Brush Research Cylinder Hone, BC Series, Silicon Carbide Abrasive, 1-7/8" (48 mm) Diameter, 240 Grit Size

Superb quality did an excellent job

Worked well. Make sure u order correct size for your cylinder. Not badly priced

Totally sold on it.Plenty of engine oil on when you use you will get amazing finish.

Excellent product , honed cylindet barrels quickly and evenly, easy to use, highly recommended.

I bought it as a relatively simple way of polishing a 1" X 2" Stuart Beam Engine cast iron cylinder after boring out the casting. I used some grinding paste as well and the results were okay. My lathe work may not have been perfect, so the Flex-Hone tool did smooth out the bore.Not adjustable of course, but any bore approximately 1" will be okay. I put the wire shaft in the lathe and held the cylinder by hand (with care) and slid it in and out - see pictures:

Great item.Purchased to fit a 68mm 2-stroke cylinder.This size in my opinion was perfect.15-20 strikes in each cylinder with a good amount of Duck Oil and it came out perfectly cross-hatched.Great item for the money.

Seen them on American sites thought I'd better try one

Bought to clean up the bores on a 1974 Kawasaki S3 Triple (400cc). I was worried that conventional stones would jam in the ports.Bought this and it did a fantastic job! It’s a tight fit and you fling oil everywhere when using - but it does a splendid job and leaves a perfect crosshatch pattern of light hone marks.Watch the videos first and be prepared for major clean-up of work-piece, bench, ceiling, you……