Bora Jigsaw Guide For WTX or NGX Clamp Edge. Use for making Straight Cuts & As A Steady Guide for your Jigsaw -542009

Works great. When sliding this jigsaw clamp along the track of the Bora edge guide, there's a tiny bit more slop/looseness than I would prefer, but then again it is made of plastic and it's inexpensive, but it works fairly well so this deserves five stars. It is made of plastic, so I can't expect an extremely tight tolerance, because the plastic being a softer material needs more clearance to move freely. This thing works great though. It's a fairly accurate guide, and I've used it to make many long cuts (6 to 8 feet across) on melamine boards, and the cuts all came out straight and are aligned to the edge guide. It's certainly way better than freehand, and trying to overcome the natural blade drift of a jigsaw without a guide. This tool was a good buy, certainly exceeded my expectations.

great item

Unlike their circular saw jig (which you kind of have to dedicate a saw to, unless you really enjoy fiddling with awkwardly placed set screws), this little jig couldn’t be more convenient. It’s more of a sled than a jig: the saw slips into place and you hold it there while the sled rides up the track, producing a dead straight cut. Bear in mind that you need about three inches of solid stock to the left (and only the left) of your cut to support the clamp. And if you don’t have something supporting the off side of the cut, you’re going to have to pay close attention to keeping the blade vertical to avoid beveling the cut. And the bora clamp is NOT self-squaring, so you have to put some work into laying out the cut. But if like me you’re incapable of holding a jig saw to a straight line (even with the typical saw’s rip guide) and too lazy to carry your table saw around the house, then this little sled (especially if you already have the clamps) is well worth it.

Not that great; looks flimsy and don't slide smooth on clamp edge

I just got into using a jigsaw to do art and hated I couldn't get straight lines. Had a friend tell me I needed to set up a guide and my boyfriend happened to have the long rail attachment for this! It works great to create the straight lines I needed!

Has already helped me often in the workshop. A good idea from Bora.

Great concept. Just make sure you have the right clamps. They do not fit the older edge clamps!

Cheap plastic that does not fit the WTX track, nor move anywhere close to smoothly, which negates its purpose. Photos appear to show it as metal, but are misleading. Fits my Bosch jigsaw, but that's where its usefulness ends. Great idea, but execution is a total failure. Much much easier to use the problematic WTX as a guide by itself, and abandon this so-called guide.

it would be better if it made of aluminum metal more durable not easy to break.

Bora markasını geç tanıdım Kaliteli ürün çıkarıyorlar kullandığımda tekrar yazarım

Does what its supposed to do and does it well..i have problems with power tools being left handed..this makes cutting straight lines easy

ottimo per quello che devo fare

it fits my makita jigsaw