Flotec FP0F360AC Cyclone 1/12 HP 350 GPH Pumping System

Exactly what I needed.I wanted to be able to wash my cars in my garage, however, there is no drainage system in place.My garage floor has a slight pitch where the wash water pools to one side of garage.The pump is very powerful and quiet, but where this product excels is that it’s able to remove almost all the water on the floor.Unlike other pumps I’ve tried, this one has no float switch to automatically engage it, which I like.It is manually operated by plugging it in. Therefore, there does not need to be a minimal amount of water in the floor for it to operate. The suction part has the openings to let water in on the bottom of triangular “pick up.”It removes almost all the water, leaving about an 1/8 of an inch of water left on floor.I run a 50’ hose from the pump out to the back of my garage. The pump has plenty of power to move water under pressure over a large distance through a standard size garden hose.Highly recommend!!!?

Product was delivered as ordered and on time. Implementation was straightforward and instructions were clear. I used the pump to backwash my backyard, probably 4in of standing water in about 50 sq/ft of space. The time taken was probably about 8 hours one day, 4 hours the next. Took a while as i was using a large 2in hose (Blue Devil B8257 Backwash Hose, 2-Inch ) to pump about 100 ft. Next time i would try and use a larger pump.All in all this was a good product that performed as expected. I will update this review if i use it again.UPDATE: Pump still works as expected, however if using a standard garden hose on the intake side, the pump can collapse the hose and limit flow. Suggest using a hard pipe or some sort of reinforced hose.

Just what I was looking for!! Easy to set up, not noisy, and sucks water quick!! Right now that is monsoon season, water is not wasted in pods in front of my home and to transfer water from a 40 gallon bin to trees

This pump was purchased to replace an exact pump that was going south after 8 years of removing gunk from the bottom of our Koi Pond during our weekly cleaning. On the original pump no lubrication or maintenance advice was given. But I always ran clean potable water through the pump and then a blast of pressure washer pump oil before putting it away (basically the pressure washer pump solution was 89% water 10% antifreeze and a tad bit of water soluble oil). This new pump recommends the use of mineral oil (baby oil) after each use. So now: clean water and baby oil after each use.

I've only used it once since receiving it.Works exactly as described. Shipped quickly. Easy instructions to follow. But buy mineral oil because you have to prime it every time you use it. 3 single use packets are included which was nice.