The lifepo4 4s 100amp bms has a display port. what is the display that works with this bms?

The lifepo4 4s 100amp bms doesn't have a display port.

Will this work for the LifePo4 280Ah cells?

Yes and no. Yes, it will work but only to 100A. If you draw less than 100A at any one time from your 280Ah cells, it will work. However, if you have an instant power draw that is larger than 100Amp, the BMS will limit that to 100A, leaving a lot of reserve amps in your cells to be used in time. In this case, you will be starved of Amperage and it will not work to the full capacity of the cells. On the other hand, you should never have such high Amp draw spikes (if you wish to keep the batteries healthy). At the same time, charging and balancing the cells will take almost 3 times longer than if using a 280A BMS. I am not 100% sure, but if I remember correctly, this BMS limits charging values to 40Amps.

How do I get support?I purchased 2 last year. I just installed and both read eeprom error

I installed one several months back with no problems. Make sure to wire it correctly. I recall something about the B+ and -. Contact the manufacturer.

ASIN	B09H492KR9
Best Sellers Rank	#77,466 in Electronics ( See Top 100 in Electronics ) #1,161 in International Power Adapters
Manufacturer	VNSZNR
Manufacturer reference	LPF-BMS-16S100A-BT
Product Dimensions	16.51 x 2.29 x 6.6 cm; 558 g

LiFePO4 BMS 16S 100A 48V Smart Bluetooth Lithium Iron Phosphate Battery Management System PCB Protection Board with Balance Leads Wires and Wireless Bluetooth Module for 3.2V LiFePO4 Cell

Detalles

Descripción

Presupuesto

Reseñas

Preguntas comunes