Thermalright Thermal Pad 1.5mm 12.8 W/mK, 85x45x1.5mm, Non Conductive Heat Resistance, Odyssey Silicone Thermal Pads for PC PS5 PS4 Laptop Heatsink GPU/CPU/SSD/VRAM/LED Cooler

Thermal pads are work better than paste! Easy to apply and assures full coverage without mess, my PC runs smooth with no heat issues. They are worth the money as these last longer. I recommend this as someone so likes to build PCs for myself and friends.

Worked great on my M2 MacBook Air. If you do the MacBook Air hack, buy 2 of these. Was able to cover the CPU / GPU and Ram but didn’t have enough to cover the flash storage. Also google a diagram of your logic board so you know where the pads should go.

My intended purpose for this thermal pad was to be paired with the:JEYI Copper M.2 HeatSink, Passive Nvme SSD Heatsinks with Copper Fins - Finscold Q80( https://www.amazon.com/dp/B09C6HCVLT?psc=1&ref=ppx_yo2ov_dt_b_product_details )sandwiched between a Samsung 980 Pro 2TB as a RAID 1 UNRAID Cache, and this thermal pad fit the bill perfectly.I was able to use a scalpel knife to cut an outline of the NVMe SSD and cut the pad practically perfectly in half and it cover the SSD exactly as I needed without any unnecessary excess on the sides with just a little bit of overhang at the ends that I just cut off, before the SSD would run at about 40c-55c+ under load but after using this thermal pad instead of the provided thermal pads with the heatsink I was able to see a 1-2c decrease in temp over the included pads.Overall very satisfied with this product and would recommend.

The Seller is great. My package came earlier than expected and was packaged professionally. The item was fairly good in respect to the thermal pads being the correct thickness. However, the plastic side that you need to peel off was rather hard to remove. Other thermal pads that I have used in the past, were easier to remove, but this brand was a little bit difficult. Other than that, the brand does what it is supposed to do. I also recommend that you need to be very careful and exact when measuring and cutting this product because there is no room for error when it comes to the amount, they provide you in the package. If you feel you might make a mistake, I suggest you get an extra package in case you make a mistake. All-in-all, the product does what it is supposed to do, you just need to make sure that you measure and cut correctly and you might have better luck than I did trying to remove the plastic. I had to use an X-acto blade to remove it.

Seems to be working fine. I am no longer having overheating issues after replacing my old thermal pads.

My slightly older RTX 3080 is ~8°C cooler just by adding these pads. Pads are nice and plyable, but still firm enough for solid conforming to components.

I am adding it to a m2 data chip

This is a great item to have on hand when building a PC rig; helps to keep your NVMe load temps down to a minimum to avoid data transfer throttling due to high transfer speeds in which NVMe temps may go up.