Project Box IP65 Waterproof Junction Box ABS Plastic Black Electrical Boxes DIY Electronic Project Case Power Enclosure 7.87x4.72x2.2 inch (200x120x56 mm)

Easy to drill into, space is good and I like having Screws instead of snapping on the cover. Takes a bit to get the rubber seal in place but not to difficult if you stretch it while putting it in the groove. I'd say it makes it pretty waterproof. I'm using one outside so if it leaks thru their seal I'll update, if it leaks thru the seal for the holes I made then bad on me.

Nice heavy plastic, water tight project box that seals up tight. It has a screw lid. Works well for intended use.

Worked well, the box is much more rigid than i expected, not sure anyone else would use it for the application i did but it was perfect! No complaints!

The price is right. If you've been looking around for a similar project box at any of the electronics suppliers, you know how unbelievably expensive they are. This one is very reasonable in price. However, there are a couple of things you should be aware of, especially if you want the box to be water-tight. It comes with a length of gasket material, but the gasket isn't a fully-formed O-ring. You just have to jam the length of gasket material in the groove in the box and hope it seals properly. Also, there aren't really good drawings for the box available, so if you're designing something to fit inside the box, you'll have to make some measurements when you get the box. No 3D models available, either. Also, there's two threaded standoffs in the bottom of the box, but there's no mention of the thread pitch of the inserts, and it doesn't come with screws for those mounting points inside the box. Well, I figured it out for ya - it takes #8-36 screws, so order some of those when you order the box.Outside of that, the plastic is good quality and sturdy. If you're willing to do without things like proper drawings or an o-ring seal, go for it!

Good project box, seals up tight. Heavy plastic. Screw lid.

This box works well for its intended purpose. Price was right.

Nice little project box. I was housing an audio combiner to send two computer headphone audio inputs to a single headset output. The necessary cable pass-through openings were made with a coping saw and cleaned up with a pocket knife,Cover and sealing gasket more than expected, project successful and now protected agains handling damage thanks to this box.

Big