Label Like a Pro! 🏷️
The USUPERINK 3 Pack Compatible Heat Shrink Tubing Label Tape is designed for Brother P-Touch label printers, offering a robust solution for marking cables and wires. With a width of 8.8mm and a length of 4.92ft, these labels are not only waterproof and grease-resistant but also feature a 2:1 shrink rate, ensuring a secure fit. Ideal for both professional and home use, this tape is compatible with a wide range of Brother printers, making it a versatile addition to your labeling toolkit.
E**K
Great for marking wires
They worked great to print, then shrink rap the label on the wire. No problems yet. I will buy again.
P**C
Works but needed a mod.
Since my model PT-D210 was not listed it would not work. But after covering the bottom left hole works like a champ. Labels a nice and durable. Do recommend using bold print to make it easier to read.
B**N
IT/Cabling Pro Must Have
Get way to label cat5/6, coax, cables, wire in an outdoor, commercial, industrial, dusty, dirty condition. I use for labeling CAT5e, 6, 6a, fiber cables in outdoor, damp and high wear locations.
S**E
Sometimes an item is just what they say it is
I am wiring my breaker panel. I wanted to do a clean job labeling wires. I looked at lots of different labeling solutions and came up these Brother compatible heat shrink tube label cartridges.When I first printed one it looked so tiny I did not think it would fit the wires. The photo here shows a 12 gauge romex conductor fits perfectly. Same goes for 14 gauge. A little heat and they will shrink perfectly on the wire.I printed these on my old Brother PT-1750 label printer, so I can confirm it works fine.
A**F
Good for the price. Worked 100% in Brother Device without Issue
The price is great. As good as the more expensive stuff. I used this heat shrink to label wires in a marine (boat) application. I had one small failure to feed problem that wasted about 6" of tube. That appears to have been a fluke. I've since gone through all of the cartridges I purchased without issue. I'm back to buy more. The length in each cartridge is pretty short and the waste on a Brother P-Touch is pretty high so plan on purchasing more than you think you might need.
P**N
If i had only known...
I can't believe how many years I've gone ignorant of Brother label maker shrink tube. I've been hauling labelers on planes and printing wire labels sideways so i can wrap normal label tape sideways since forever. This stuff is the greatest! Prints beautifully, shrinks beautifully. One precaution is to divide the label 'size' by Pi... (3.14)... to get the tube diameter! Haha, but 5.8mm = 0.70" = no go on 16 gauge MTW, even 18ga MTW is a tight fit. This size is good for signal wiring. Works in all my old timey brother labelers and my PTD400 as well.
C**R
Impressed!
Okay, so maybe it's not the greatest heat-shrink (it's thin, no adhesive, and easy to wrinkle), but the fact that I can print inexpensive heat shrink labels with my super inexpensive and old label maker is just too awesome. I was getting ready to spend hundreds on another machine and labels; with these I can use my ancient label maker and it's completely effective and functional! For a hobbyist, these are great!
A**A
Works as expected
Used this on a P-Touch XL printer. Printed well on the shrink tubing. Used to label cables. It's not very thick but it works well to label your cables or harness. Make sure to order the size closest to the size of the cable or wire. It shrinks about 2 to 1.
Trustpilot
Hace 1 semana
Hace 2 semanas
