GXARTS Driver Side Bottom Cloth Replacement Seat Cover Gray Compatible with Dodge Ram 1500 2500 3500 4500 5500 2009 2010 2011 2012

Looks like it came from the dealership. Fit perfect

I’ve been using for 3 months and the seat cover is holding up just fine. I did not replace the under cushion as it did not seem to be too worn out. As others mentioned, make sure you get your hog pliers and it’s straight forward.The only thing I had to modify was underneath the front of my see where the plastic loops around the frame. It kept on popping off, so I ran 3 self tapping screws with a washer head so it would not rip through the plastic. No longer an issue nor can you see them unless you look under the front of the seat. I could always share a picture if someone needs.

Only one thing gives away this as not original- white stitches as opposed to black.Looks great other wise

I just finished installing this on my truck. It looks great and matches perfectly. However, it took a little bit extra time cause I had to take the front clip off the old seat cover and put it on the new one since the new cover came with a clip on the front that would not work, you can see in the pictures the different configuration of the two clips . The one is still sewn on in the picture is the one that came on the new cover. The one that is held up next to the old seat cover is the one is needed.I’ll give it a better review, except I had to sew on the other one which with a bit of extra work

35 year career mechanic opinion.....this is the second seat cover in 14 years. There are plenty of Youtube videos out there on how to remove seat from truck and how to remove bottom seat cover and foam from seat frame. It is rather straight forward with a couple basic hand tools. You will need a set of hog ring pliers and 1/2" rings. $15 for both on Amazon. Don't use zip ties to secure the seat cover to the foam. They will break, and the can also cut the material from the underside and cause a hole to form. It took about 45 minutes to completely remove seat from truck, change foam and bottom seat cover and install seat back in truck. I did spend some time putting a couple layers of duct tape on the underside of the new foam pad that I also replaced. I did this for added protection on the high wear areas I noticed on the bottom of the old foam pad.The material and stitching appear to be of good quality. I did notice the side panel that is next to the driver's right thigh is not of the same material as the factory seat cover. This panel is not viewable and the difference is not noticeable once installed. Merely noting there is a difference. Otherwise, the material appears to be identical to the stock seat cover.Also, there are 2 places on the factory seat cover that have pre-made holes for seat component mounting screws that this seat cover does not have. It was not a showstopper, and my work around was simply to screw thru the seat cover material. Both of these instances are on the left side panel that is covered by plastic trim.The fit was perfect. The color match was perfect.I replaced the seat bottom foam at the same time, and I believe this new foam filled out the new seat cover unlike some other reviews that claim the seat cover is saggy and/or does not fit correctly once in place. Because I replaced the foam, I physically sat higher in the truck. So much so, that I had to readjust all my mirrors. My point is......regardless of how well your foam looks it will likely be broken down and settled to the point this new seat cover will sag unless you change the foam also.I would highly recommend this product.....with a new foam seat bottom also.

Fit perfectly.

This was a 100% perfect match to the seat in our Dodge Ram. Aside from being brighter, you would never know. Packaged well and delivered quickly. The upholsterer was able to install it within a few hours.

Good