GE WH01X10310 Genuine OEM Timer Knob (White) for GE Washing Machines

Perfect fit .....easy installation......works great!

Exact fit. Worked fine.

Parts arrived in a couple days, I ordered both parts knob and back plate as I wasn't sure if I needed both the teeth on my old knob were broken see picture #1 and new knob with lots of new teeth #2 and completed replacement #3 Clip is included with knob for those who might wonder Replacement was so easy took maybe 5 -10 minutes Unplug washer, pull knob out as if you were choosing load type , behind the knob is a small white plastic clip that holds the knob in place , take a small screw driver and gently slide off the small plastic clip, knob will release so you can pull it straight off shaft Keep in mind which direction knob was turned so you can line it back up when replacing , then gently pull the larger white circular plate, off shaft , keep in mind the position so you can put it back on the same position as removed so the teeth line up While I had plate off I took a paper towel and wiped off 10 year of accumulated dust around shaft Then placed the new circular plate on the shaft making sure to line it up as the old one came off , if you look closely you can see where the teeth of the new knob with fit in to this plate around the bottom of the shaft Place the knob back on the shaft in the same direction as the old knob came off , the next step is a little tricky putting the clip behind the knob, the space is very small behind the knob and the plate You may need a flash light as its hard to see Hold the clip between thumb and index finger Gently slide the clip on the shaft behind knob , after I go the clip on the shaft I gently pushed the flat edge of screwdriver against the edge of clip making sure it locks into place Now gently push the knob down to select a load type You're done !!!! This was my 2nd repair to my GE washer first was pressure valve and plastic line over flow line ( got those parts thru amazon too Thank Amazon !!! I really enjoyed completing both repairs and it saved me about $500 -$600 as hubby wanted to buy another washer instead of repair I'm a senior and fixed it myself Hope this review helps others My camera wasnt very clear in taking pictures

I bought this after searching DIY videos for a slipping washer knob. This item was a perfect fit for my GE washer and it was simple and easy to remove the old one with a pair of needlenose plyers and snap this one on. It works just as well as new.

I have friend that's been using pliers for over a year now. I happened to be there and witnessed this craziness. I told him they do make replacements he said "I know" it seems he was afraid of the work that must be required to replace the knob. The work was I used his pliers to remove the old knob shaft and absolutely no tools to install the new one. This a an easy job that almost anyone complete easily complete.

Factory part, direct fit, no issue

I noticed that the Cycle and Spin/Speed Combinations knob on my washer was basically spinning freely. After some inspection, I was able to find the clip that was holding the old knob in place and remove the knob. I was able to purchase this genuine OEM part to replace it.The part comes with the knob and a replacement clip to hold it in place. My one gripe about this listing is that it doesn't show the back of the knob or the fact that it comes with the clip. This knob has teeth on it. It is not one of the D-shaped knobs that you use to select load size or water temperature. People are giving this a negative rating because the picture and descriptions are crappy even though the part number is correct.I have included pictures for future shoppers. The first two pictures are of my new knob. The third picture shows how worn down the old teeth were.