Pack of 4 Universal Aluminum Vehicle Hood Pins - License Plate Lock Clip, Quick Release Lock Latch Bumper Diameter 1.25 inch

Great for the money! Secures tightly with an almost flush clean look.

It’s great it fit like it should and shipped with all hardware

I liked the amount it came with and the tactile response of the buttons. I used this for my motorcycle seat pan made from fiberglass. It was either screws or u bolts, fortunately I found this quick release solution. I didn't like that the tip of the rod wasn't completely round, I've purcchased a different brand before and the rod tip was round, it looked as if it was more capable of locking in at angles as opposed to this version which gave me the impression that I needs to be dead set at 90 degrees to lock in. Nonetheless, it was a nonissue for my setup. I recommend this for any panels that require quick release on the other side as opposed to bolts! The time reduced from having to spin nuts is worth the little few bucks this costed.

Really like these and used them for a quick removal of my front bumper cover. Ran into a couple issues; one on the site's description/instructions of hole size and the other about the latch.Regarding the latch, there is a threaded insert that goes into the retaining body that composes as the latch. That is loosely threaded in and it may fall apart on you. If so, just put some loc-tite on the threads and screw it in with a couple of small drill bits bridged by a screw driver (or however you can would like). You can thread it back on by hand but can't really torque it.DO NOT FOLLOW the instructions which says to drill a 1.25" hole, but that's the diameter of the largest part of the whole retainer, so you wont be able to mount it to anything. Drill a 3/4" hole, anything larger the latch will have play. The mounting diameter of the retainer is 0.720"Again, still worth it compared to the name brand ones. Just wouldn't use these for mounting serious things like hoods unless if you had about 20 of them.

One was broken right out of the package. Head piece would not stay secured to the shaft. The second did the same thing after I used it about three to four times. I am using these to secure a piece of material to a rack on my ATV. Hard to explain without photos. There is very little weight involved, yet the pins could not or would not hold.

Great price all the parts have a good fit and finish. Works like they are supposed to.

I’ve had two of the four buttons break and I am not sure how to contact them however no replacement has been offered yet, I’ve only had them installed on my car for 2 months at the most and they are already broken.

One out of the 4 latches came broken