bbflyForscans VINT-TT55502 ELMconfig USB modified For all Windows HS-CAN/MS-CAN

I bought this tool to carry out some adjustments to my Ford Focus TDCI 2 litre and clear some DTC codes.I installed the downloadable software shown in the advert and installed it on a Windows 10 tablet and it worked flawlessly after connecting the device to the tablet and installing the device driver.Using the software is relatively simple but for novice users I would recommend doing some online research before making any adjustments, other than basic ones.The software identifies any problems and offers suggestions on why the DTC codes exist and how to resolve them.The device can scan all modules of the Focus by using a switch on the side of the device. The software steers you through this process to enable a full sweep of all ECU controller systems.For the money this is a valuable and easy to use tool which is essential in maintaining your Ford Focus. It has features such as forcing a regeneration of the DPF for cars used in mainly short trips and other useful features.Overall a simple to use device, which represents good value and essential for car maintenance.

Worked great for my 53 plate mondeo. Slightly sceptical before purchasing but downloaded the software easy enough, plugged in both ends and clicked scan - found the fault code straight away (EGR valve dirty again!) and every reason to believe it's accurate based on previous issues with the same thing. Code cleared easy so no more engine light and was able to save the scan report to desktop. Very impressed!Only annoyance was that I didn't need to download the driver as stated in the instructions. I tried but couldn't get it to work, gave up in the end and just went for it regardless - it worked so I guess no need for the driver install?

Used with Forscan running on Windows 10 to diagnose an issue with ABS on a Kuga.No issues encountered in downloading/installing the USB/Comm port driver from their Web site.It identified a rear wheel speed sensor as being the issue. Once the Sensor was replaced, I was easily about to reset the DTC to clear the fault.Note, that while the device worked well, Forscan reported that this OBD device is not a recommend one. I expect they say that about all 3rd party devices.

Worked perfectly unlike the unit it was replacing.

Used this with the Forscan program to sort various issues with my Ford Focus - including DPF static regeneration and fuel additive refill and purge service operations.This has the HS / MS CAN switch, enabling you to access other modules.Worked first time, very reliable, no issues whatsoever.Don't waste your time with the cheap (less than £10) ELM 327 clones on eBay - I've tried several, and they don't work. Spend a little more and buy this item instead.The only improvement I could suggest, is that would be better if they used the FTDI USB-to-Serial chip instead of the Prolific CH340. (The CH340 is fine, but FTDI is better as you don't usually need to install a driver.)

It's a great product and I would have given 5 stars if it wasn't for the need to install drivers found on the website. This isn't made clear in the supplied material.It's works well though, it's good quality and has the toggle switch for bus products . I'm using it with Forscan and had no issues

Thought it would be as simple as following their instructions, however, wouldn't connect to my car, even after re-installing the program, trying 2 different laptops, and trying all the different drivers recommended off the Forscan forums. After almost an hour of being sat in my car, I've given up as I'm almost sure there is no way of getting it to work. Shame as I was looking forward to using this for several reasons but have been hesitant about buying it for some time.

Great piece of kit, but as the title says, you'll stop need to download new drivers