Antminer S15 T15 S9 S9i E3 T9 L3+ D3 A3 V9 X3 120mm Fan Duct Cooling Shroud to 6 Inch Vent Hose

I've used 5" and 6" shrouds. This is my favorite. One tip for the uninitiated: when installing them, ensure you have all four screws in place, all the way in the shroud, and only then begin screwing them into the fan. If you screw one screw in, all the way, and then try to insert the other screws, you're gonna have a bad time.

Performs as advertised, seems to be a high quality 3d print with no artifacting. I'd like, however, to see the base on the screw plate made a bit thinner. As it is, it only allows for approximately 3/4 turn of threads to engage

Fits like a glove (Great buy) very happy

Little expensive, big, and kind of hard to install but keeps the miner way cooler than the 4 inch.

Incredible! I tried the 4" ones and the ASICs overheated instantly. These route the heat out no problem, they're running at < 80* C with an ambient temp of 90*F+. I'd recommend putting the screws in first, then attaching the fan to the shroud, THEN putting it all on the ASIC. I used 6" insulated ducting, perfect fit. These even ran a tiny bit small, which was great to slip the ducting over.

The product is great just only if they could be faster for shipping

Nice product,,fits, does what it's supposed to!

Excellent

Muy útil para adaptarlo un ducto para desahogo de calor quede muy satisfecho

Fits flawlessly onto my 6" ducting. I couldn't have gotten anything else better anywhere else. Good work.