Trains - Durango & Silverton Ready To Run Electric Train Set - N Scale 0.5 Liters

Great little start set. Purchased it for our 10 year old now he has the N Scale bug. Only disappointing thing about the set is the lack of track. But you can't complain really because it's a cheap little set.

Oi you lot, I bought this train set from Benders. For my experience of N gauge... Very poor! The loco although looked nice, kept on stopping & starting! Needless to say the loco don't look nice anymore cos I lost me temper, stamped on it, smashed the transformer into the wall, kicked the carriages around the room, stamped on them & what was left of the train set ended up in the bin & then I balled me eyes out! Chow peeps, go away, leave me alone & go on home!

Le rendu du train est bien cependant le mode d'emploi n' est pas assez précis nulle part il est fait mention que l'on ne doit pas se servir du transformateur de la boite (réservé aux USA) mais de celui rajouté en vrac. Dommage aussi qu' il est manqué quelques pièces dans la boite et d'être obligé de les demander plusieurs fois. J e reconnais cependant que chacune de mes demandes a reçu une réponse très rapide j espère que l'acheminement des pièces sera aussi rapide

Es war nicht das, was ich erwartet hatte. Die Lokomotive hatte einen Defekt

Good little train

Exelente set de ferrocarril a muy buen precio, llegó la mercancía en buenas condiciones en tiempo y forma lo recomiendo ampliamente gracias.

If your train doesn't work initially, READ THIS before shipping it back. Initially my engine did not work. Remove the tiny screw on top the engine and remove the housing. Take a 9v battery and hold the terminals against the right and left halves of the train. The little DC motor should fire right up, spin the worm gear, and turn the wheels. This at least proves the engine is OK. After i did this, i re-installed the housing and the engine did not work again, even though the track tested out fine (wtf!). All it took to make it run was to loosen the screw holding the housing on. If it's screwed in too tight it will cause a short, and not put the DC through the motor. I read through the troubleshooting manual and all sorts of engine troubleshooting forums, and none of them suggested this. Other than that initial headache, the train works great!