AUTOOLFuel Injector Cleaner Kit Fuel System Cleaner, Non-dismantle Fuel Injector Cleaner Tester 1000ML 150PSI Automotive Intake Valve Manifold Throttle Body Catalytic Converter Cleaner

Good quality, you should be able to get years of use out of it. I did two cars today and both are running much better with smoother idle and driving. It has a great case and came well packed with foam to protect the regulator gauge. Instructions are very basic so don't expect them to cover you car, just watch you tube videos to figure it out. I used this on my Ford Flex and Subaru Outback, worked great. On the outback, I pulled the fuel pump fuse, used the large plastic connector to connect to the fuel rail. You have to connect the end of the line/hose with a hose clamp to the connector. I crimped the return hose with a pair of vice grips and a towel to protect the line, this is done so you dont just flush the cleaning fluid back into your gas tank. Filled the can with B12 fuel injector cleaner and sealed the lid. Tighten the valve at the bottom of the can before you connect your compressor hose, then you can adjust the pressure level for you car. Once the level is correct, you can open the bottom valve to allow the cleaning fluid to pressurize the line and start the car. Let the car run until it dies and the can is empty. Be careful as the cleaning fluid is very toxic. Wear eye protection and gloves. De pressurize the can with the button on top before taking the lid off or disconnecting the line. On my Ford flex the car would not start with the pump fuse or relay disconnected, so there is a piece in the kit that will fit in the line on the car and a cap to seal off that line while the tool is connected. Great stuff! Saved me a ton of money. I got this kit for about 85 dollars and picked this one because it seemed to have the most selection of adapters/connectors. A typical fuel injector cleaning service from a shop is around 60-100 dollars so after your second use you are way ahead.

This kit is great quality worked on a Porsche cayenne coolant system flush/fill. Worth the price no leaks.

Awesome tool/kit for doing fuel induction services. However when using some of the cleaning agents in the tool, it did sorta melt the inside of the clear hoses with excessive use and different brand induction cleaning agents. I used BG 44 K with great results. I’ve also used valvoline’s intake induction cleaning solution that’s blue and I’ve used ESP intake cleaner and their GDI cleaner as well. I don’t know if it was the mix of different agents that caused the breakdown or the clear hoses (I doubt it cause they are all the same main ingredient/chemical) or what, maybe it was the brake cleaner I ran thru them to clean them. Either way the kit does its job well however I would just keep in mind the clear hoses aren’t invincible and could breakdown depending on what you run through them.

Works as described

I used this to help clean my cats, worked great. There are videos that explain the process.

Funciona muy bien

ing ssim straP

Es un equipo muy completo y se mira de buena calidad ya lo use la primer vez exepto una manguera de las pequeñas se aflojó con el líquido después volvió a normalizar...espero que la duración no me desepcione