BEAMNOVA 100 Sets of Metal Button Supplies Blanks 75mm / 2.95 in (Approx. 3 inch) for Button Pin Maker Machine, Matte-Back Metallic Round DIY Badge Press Making Parts

I use the 32mm buttons and they are better than any other button I’ve ordered on Amazon and I order hundreds and hundreds at a time.These are so thin and flat and look so much nicer finished. Other brands/styles are raised causing your paper to pinch and the buttons to look puffy.They are easier to make and there are no flaws or mis-presses. They cost a few more cents per button but the quality is worth it. I will be ordering these from now on.

It hard to fix and metal backs in this size and my button machine doesn't work with plastic. These are sturdy and look fantastic upon completion. I have purchased this product from them twice. Quality appears consistent. Would recommend.

Just wrong size

Works perfectly with my 44mm chi button maker. My only regret is I didn't notice the back pin on these align to the middle and the ones that come with the chi button maker are more towards the top than the center. This is only a concern though if you have premade packaging that you need to adjust the alignment like I had to.

absolutely perfect will buy again

1. The front and back don't fit together.2. The back is extremely thin and bends too easily.3. For some reason, about 1/3rd of the lip around the back often gets blown out in the opposite direction. I have to be VERY precise with my pressure to avoid this.4. Mylar films are too big. I had to trim some of them to fit.Overall junk product, avoid it. 0/100.

I ordered these button supplies in a pinch when I ran out halfway through a commission, but they're as bad as I feared.The metal face and backings themselves are okay quality. The faces are comparable to the old set I had, but the backs were a weird texture and I didn't like how much wiggle room the needle piece of the pin had. They were also shaped kind of funny, so the pin part was very difficult to fasten under the hook once opened.The mylar sheets are what really brought this review down to two stars though. On top of being thinner than the higher quality ones I already had, they were sized incorrectly. It's hard to tell, but in my first two images, the first photo is of a correctly sized mylar sheet from my old set, whereas the second photo, based on the ripple of the glare, you can tell from the start that these sheets don't fit in the button well because they're too big.I went ahead a tried a few to see if I could get them to work, and the following images are the result. because the mylar was too big, the edges didn't seal completely. I was able to trim each one down by hand around the circumference to make them work, but it was very tedious and I will not be doing that for all 100 sheets.

im always afraid that sizes will be wrong, but this was perfect! 44mm which fits 1.75 or 1.73in button machines, and comes with the adapter gasket as well!! WILL be buying again!