extruder

Q: Does this work with newer Ender 3 Pros?

Yes...and no. You will not be able to attach the gear to the 42-40 motors that don't have the longer center shaft. These use a 14mm (from the raised part of the motor, the circle) shaft and it is not long enough. It will not work without changing the extruder motor. Also, the input fitting will not clear the Ender 3 Pro Z rod...so if that's critical for your install, I'd look elsewhere.

Q: Does this fit on a Creality-6SE printer?

yes fits on mine, but i needed to print off a riser pad for the filament sensor. the one i used is called "Creality CR-6 SE filament sensor mount riser with cable holder for dual gear extruder" on thingiverse. but just a quick note, YOU WILL NEED 25-30 MM M3 screws. i picked up 2 at a hardware store but you can also buy them off here on amazon.

Q: Could this work with the longer lk4 pro 3d printer?

Thank you for your inquiry. This dual pneumatic extruder can be used on longer lk4 pro 3d printer.

Q: Is there a a version of this that comes with a motor?

There is a version that comes with the extruder completely build the carriage assembly and a new hand but I can't remember who makes it it's literally a plug-and-play

4.1/5

ID del producto: 509880447

Transacción segura

Comprados juntos con frecuencia

Bigtreetech Upgrade Dual Gear Extruder, Double Gear MK8 Extruder 3D Printer Dual Driver Stock Feeder All Metal 1.75mm Filament Extruder Kit for CR-10S Pro/CR-10/ Ender 3 V2/Ender 3/Ender 3 Pro Series