6 PCS House Floor Jacks Post Pole for Leveling, 11" - 16" Height Range, 6 ton Min and Max Height Capacity, Galvanized, 6 Pack

Don’t expect top tier quality, but for the price, a quantity you get if you complain you arnt happy with your life, a your bad review isn’t there problem. Second time I’ve purchased these to lift joist, other house is still holding strong over a year later an I’m sure for many more. No you can’t use these to lift the house, so you’ll need to own bottle jacks, but yes they will hold the height the jacks give, sn support the weight.

Had to reorder, there was some unknown issue. This is the second set the I ordered, they work great. Easy to adjust and solid.

Just unboxed and am impressed by the quality. One complaint, both ends of the box had opened in transit, and 3 of the cap nuts had gone missing. The one remaining was still on its bolt, but very loose. The other 3 bolts, two were still in their holes, one was floating loose and could easily have been lost. I’m on my way to the hardware store to see if they have any cap nuts this size. I’d expect to pay at least a dollar each. Will be tomorrow before I can try to install them.

Perfect for leveling an off grid, above ground deck. The quality is very good, easy to use and adjust on ground with a paver underneath. Screwed right into the 2x10.

Used to add support under my office area. Worked great and easy to use. They appear strong and sturdy and should last for a while.

Didn't work for my application they were to weak. You might be fine.

This was a great buy. They are sturdy and are just what they say they are. I love how easy they were to use. Would buy again and recommend you give them a try.

Easy install & solid welding

These jacks are light yet strong and were perfect for my application. A well designed product.

They work well, but lack a way to back off the extension once fully deployed. All I could do was to use a monkey wrench on the threaded section to lower it.

Need a wrench to tighten up,could have had a bar attached to tighten up did the job.

The actual nuts on the threads are a sloppy fit as well as waaayyy too light duty to support any type of weight. They're metric as well. I tried using a standard & metric thread nut and it won't go on. The threads are actually undercut to a 18.5 mm thread, the nuts are 19 mm. The only way to fix the solution is to use a locking nut, a nylock won't work very well.

This product looked to weak for what we wanted to use it for. Returned them.