Upgraded WB30T10133 Range 9"/6" Dual Radiant Surface Element Compatible with GE Hotpoint Electric Stove, WB30X24111 10" Haliant Surface Element Replace PS2321567 AP4345739

Great price easy to install and it works perfect

I was hesitant buying a non OEM burner replacement as other listing had bad reviews or complaints that terminals weren't the same.My Ge large burner would only heat the outer ring.I could see the old burner had an issue with the filaments so I knew i just couldn't fix it.I bought this and installed it in about 20 mins. It includes a terminal adapter wire as one of the terminals didn't match oem wires. The jumper wire was a little loose so I did have to crimp it.The holes that match up to the clips were slightly off but I still managed to get it locked down.Fit is perfect. Heats quickly and now I have the small and large burners back.Compared to buying oem at almost triple the cost...this is a great alternative.

This would have been a snap if we had found the adaptor connectors under the Styrofoam packing! As it was it took some finagling. The other problem we had was figuring out how to remove the glass top - The actual installation was straight forward and the burner works fine except the center (smallest) burner will not heat but I think it is because we did not know about the hidden adaptors or instructions. I am hoping that problem will be remedied when we dismantle the glass top and re-do the connectors.

It worked perfectly. Just look at the exact model number. Quality was good.

Great, very easy to install

GE slide-in range. Had problems controlling temp on front (3 ring) burner on JS750SF3SS. This review only applies to that unit and this burner. Made the mistake of changing out this burner when I should have changed out the controller (see separate review). Advice:1. If you have problems controlling the temperature of a burner and the burner is working (heating up), try changing out the controller first. It is MUCH CHEAPER AND MUCH EASIER to try this first instead of changing the burner.2. Make SURE you have the correct model number. Do your research on GE website. Find parts numbers, diagrams, and assembly views for your range. I even called them, got the correct part number and (higher) price.3. Don't necessarily rely on YouTube videos, unless the model is the SAME. They might look the same but taking it apart can be very different. Use the assembly diagrams for your range from GE. The videos showed a couple of screws and lift up the top....my unit was significantly different and much much more difficult. With respect to only my unit, I would not recommend changing this burner for an amateur DIY'er.4. On the flip side, do use the videos. Once you get into it there are a lot of similarities.5. Disconnect the power. Take your time. Disconnect the wires one at a time and make sure you reconnect the wires correctly. Take pictures if you doubt yourself. My situation required the use of the two included jumpers/adapters.Changed the burner after several hours of work. Burner worked fine, although still had the same problem. Switched out the controller and solved the problem.

This is a little bit too early to do this review,But I will update depending on how long last, I put on today 4/16/25I didn’t had a time before so I installed 2 days after I received the item,So far working good, fits perfectly too.

The element heats up too quickly and the thermostat shots it off right away. Not enough time to heat the surface of the stove. I wouldn't recommend.