Fitness RealityExtended 9" Olympic Weight Plate Holder for 2"x2" Tube Power Cage

I was actually looking for one of these that was a tad bit shorter since I wanted to use it to store my smaller weights and fractional plates, since I access these often, having the shorter length, and slightly thinner tube, actually makes them easier to get on and off. So this worked good for that. But if you want to use it for heavier weights, I think the ones that tilt up slightly are better. This one kind of goes out 90° from the bar. You can see that compared to the other one I have below which tilts up slightly in my photo. But this one does seem strong enough to hold a lot of weight if needed.The clips that come with it might as well not be included in my opinion because I don't use them. And although they fit this weight rack bar fine, they are slightly too small to use on barbells. But since I didn't buy this for those clips, I don't deduct any points from the rating for them being somewhat unnecessary. I guess in theory you might use them if you had weights stacked all the way to the end and you were shaking your machine and worried they would come off but that's not the case for me.

Well done. Far better than others I have tried. I put up a full review on my social media. 5 out of 5 stars!

They work greeted for plate storage / weighing down a power rack

I was looking for a way to weigh down my power rack, and these gave me exactly what I needed. Great plate holders.

I bought a different brand before these were available. I like these more, but I wish there was an option to have the weight stick out the back or that rack, not the side.

Items were just as shown in the picture. Easy to install and remove. I have ordered a second set to have enough room for all my weights.

I wish they were just a little longer to hold all my plates together but depending on your plates brand, might just work fine for you.

It's sturdy and it holds a bunch of heavy bumper plates. The only thing I was a little disappointed by is that the clips aren't big enough to go on a barbell (I was hoping to use them on my curling bar). They're fine for their intended purpose though, since the plate holders have a slightly smaller diameter than the olympic bar.