Bolt Racker Handle Compatible with Ruger Mark III, IV, IV Ruger Mark 3, 4 Lite Pistols -Harden-Aviation Aluminum

Lightweight, well-made upgrade for Ruger Mark III/IV that actually helps. The aluminum ring gives a positive grip for cold or gloved hands and makes clearing FTF/FTE faster while saving your fingertips. The install was straightforward with the included wrench; the fit is snug, so a tiny spread and a dab of blue threadlocker kept it rock-solid through a few hundred rounds. For the price, it’s a simple, useful quality-of-life add.

If you don’t have one of these for your MarkIV, I strongly encourage you to get one. The instillation wasn’t necessarily easy, but once I stretched it out a little (and I mean a very minor amount) it slid right on. Has stayed on through hundreds of rounds. Looks good, feels good, and is of good quality. Very good price compared to the competitors and quick shipping time. Honestly I mean this, if you have one of these pistols, you might as well pick this up. It makes FTF/FTE’e much more manageable. Saves ya from a pinch and imo works better than the charging handle accessory that other sites sell.

Great fit.....simple to install if you watch the video. Don't need to force it to install. I had it done in less than 2 mins. Very good price.

Looks great, it work for what it was designed for.

Wasn’t sure I liked how these looked on the gun but after one long range visit I don’t care they are so nice to have. Great grip. Solid piece. Fits perfectly on mark 4 22/45. A little expensive for what it is but its purpose is worth it. Use lock tight or it will come loose.

The handle has a nice finish and is easy to install, if you use the clamping screw to spread it sufficiently to install over the end of the bolt. Take the screw out and thread it in from the reverse side with a knife blade or other piece of metal in the gap. Screw the screw in just enough to spread the opening. Slide over the bolt, remove the screw and reverse the screw and tighten. Very easy with no damage or scrapes.

When my Tandemkross halo ring kicked the bucket, I figured I'd get a more reasonably priced one. Well, this one is low priced but doesn't fit my Ruger Mark IV. This is going back.

Makes clearing failures to eject much easier and faster to clear. Put 500 rounds thru the Ruger with it attached and no issues. Easy to install but follow the directions. If it will not fit on easily you are not installing it correctly. Figured this out the hardway.