Bolt Dropper 100 Pack #4 x 1in Wood Screw - Stainless Steel Screws with Flat Head Phillips Drive - 18-8 (304) Corrosion-Resistant Screws for Indoor or Outdoor Wood Use

This is a good product for basic repairs. I bought these screws to replace the 1 inch screws on all my exterior entry door hinges, dead bolt, door knobs and striker plates, as a security enhancement.I read all the reviews looking for the best product at a reasonable price, This product got high marks with one exception: Several reviews commented on how easily the screw heads rounded out. I purchased these screws anyway.I only had 1 screw head "round out" out of the 50 I used. The reason it failed was because I used too small a drill bit for a pilot hole, used a cordless drill to install the screw all the way in and it rounded out because I allowed the screw driver drill bit head to spin on the screw head once the screw it self had seated. So that is the only problem with these screws, "user errors".My suggestion is to buy these screws and use a little discretion in using them. Use the closest size drill bit to the screw for drilling your pilot hole all the way in. The less resistance the screw meets along the way the less chance you have of stripping the head out. Next, if using a cordless drill to set the screw in, run it all the way down to the last 1/8 to 1/4 inch and then go manual with a screw driver to seat the screw. Better to take a minute and seat the screw this way than "round out the head" with too much power and have to spend more time having to get the screw back out at a later date.There is nothing wrong with these screws. These are good screws if you do the job right and don't over torque the head with a power drill during the last 1/8 inch.

Exactly what I ordered

Good product

Used these screws to build rose trellises out of pressure treated, that are being used at a beach house. Even with the salt air, screws are still corrosion free 6 months later.Just a note of caution, 300 series SS has great corrosion resistance, but these screws are definitely much softer than equivalent non-stainless screws.I would also recommend using square drive or torx head screws instead since phillips heads are designed to pop your driver out under high torque, but since these screws are soft it will wreck the head and ruin the screw. That being said, I drove about 80 of these and I only stripped one or two; you just have to put your weight into it.

durable

They are good SS screws

Would buy again

Just what I needed