AGS RUST SOLUTIONS Rust Paint, Matte Black Finish, 32 Fluid Ounces, Pack of 1

Works as advertised

I purchased this AGS product to compare it to Eastwood's rust inhibitor and Por-15 rust preventative. I've now used all three on auto frames and where I want to stop rust. The Por says it's not UV resistant so if that matters AGS is better. I couldn't find any real difference between Eastwood's inhibitor and AGS. Both flowed about the same and dried rock hard and just the right sheen. The main difference comes down to price... after taxes, shipping and the handling cost to dent the cans ... AGS came out a bit cheaper. All in all, for the money, I'm liking this product !

I used it for the roof of my jeep cherokee which was starting to surface rust. Roughed up the roof/paint with a 4.5" scotch brite wheel on an angle grinder. Then applied paint with a 6" roller brush. It went on easy and dried fast in our high humidity. The only negative was the way it was shipped. Paint had leaked out all over the can so i couldnt read the instructions. Amazon should of shipped it in sealed bag or something else instead of the standard box and puffy bags.

Good product, could probably even dilute it and it would work well.

The adhesion properties r fantastic. This stuff works good as a primer to.( If ur painting something black ) just like any painting u need to FOLLOW the instructions. Every paint is different. But usually with rust converter paint it must be ruff (40/60/80 grit on bare metal) if u want to paint on bare metal. Otherwise just get the flaky rust and paint off . And blow it off with the air hose and or wash it with some dawn dish soap, and it will work out good . Just follow the instructions. Don’t take short cuts , the end result will be affected by ur preparation before u paint

OK at best. Slightly gummy when cured. Tried bruhing, foam roller and spray. Does not lay down well. Good enough for chassis paint if its not going to be seen. Not a replacement for Por 15.

Paint is very thin and runny but yet coats exceptionally well. Starts drying instantly and appears to make a nice thick coat. Best i can describe it as warm honey. So far very happy im doing 2 coats as I’ve found spots i missed the first coat. I used a brush and it does leave brush marks. Appears to be very durable and gave it a good test while installing new press in bushings. Very happy

great product