Armored Fiber Optic Cable Stripping Tool SI-01, Longitudinal & Window Peeler, Mid Span Stripper With Adjustable Cutting Depth, 2/5" to 1" Diameter (2 Spare Blades)

I’ve used a few different cable slitters in the past several years and I found them to be a pain to deal with and so expensive, I think the first one I purchased was over $250 and the replacement blades were like $60. I work with fiber Optic cable and having to deal with some pretty gnarly cables, some double armored. What’s great about this cable slitter is it has handles on both sides, I never understood why a lot of them only have a grip on one side it made it hard to cut into the cable and keep it at the right angle as you slit it. I also had issues with blades breaking to easy and even had issues with pieces just vibrating off while just sitting in a tool bag. I like the way this one is designed, simple not a lot of little parts to lose, blade adjustment is so easy just turn the adjustment wheel, no tools needed to adjust blade depth. Blades hold up well plus comes with spares which are also easy to replace and of course there are grip on both ends. If you strip a lot cable like I do, I highly recommend this tool. I have nothing to say negative about this stripper so far.

For the price point this tool works great, just tested on 1999 dual steel strength member and worked flawlessly. I would highly recommend this tool for any fiber tech.

Very cheaply made. The blade snapped as soon as we started stripping wire. Flipped it around and it snapped again. We’ve similar products in the past that were far superior. Product was ultimately unusable.

Works as it should but, hing pin broke 3rd strip. Fixed with 3/16 bolt and nut.

Bien

Quality is good, but good luck holding the cable in place without kinking or breaking tubes or worse the fibers

Far more robust than I had hoped for. The tool is 8.25" long, 3" tall, & 1.25" wide at the middle. The steel blades are .05" thick and protrude into the insulation 5/32". Mine came with a much appreciated extra set of cutters. These can be sharpened using the edge of a stone. The brass knife holders are not designed to be refitted with new blades which is the only improvement I could ask for. If I get to the point of needing to replace the blades I will tap threads in the brass knife holder and add a steel screw to clamp the blade. There is no brand on the tool so good luck ordering oem replacement blades later.

Esta herramienta hace todo lo que debe hacer solo aprende a usarla y te va ir genial