Bosch RC2124 3/4-Inch by 12-Inch SDS Plus Carbide Rebar Cutter for Drilling with Rotary Hammers, Gray

I drilled down with a hammer drill and bit until I hit the rear, then switched to the rebar bit and regular drill mode and the cutter is still sharp and ready for the next hole.

Good value for the money

The product works great, however, they really need to ship it in a cardboard box. The first paper envelope showed up empty. The second paper envelope was basically all tape, but the product made it to the destination.

I hit some rebar with a regular cement bit and couldn’t get though it. I ordered this bit and it went right through.Don’t force it, just light pressure and it will do its job.

When installing anchor bolts in reinforced concrete, I was unlucky to strike a half inch rebar. I realized that there are very few good options to remedy this problem: you either relocate whatever you are securing, which wasn't an option for me or buy one of these rebar cutters. The cutter went through the rebar in three locations and saved the day. I recommend these drill bits, which can save the day. I only drilled three holes with the bit but saw only minor damage to the bit. Great product!

I returned the bit because it would not cut through rebar as advertised. Instead it wallowed out the hole where and additional shim was necessary to get the anchor to hold. Not only that, the full amount of the refund was not issued. I am requesting the full amount. Not only did it waste my time both by me having to repair the hole but also by having to pack it back up and ship it back.

This is a great cutter for going into concrete with rebar. I was installing my car lift in my garage and was trying to drill with regular concrete bits, which didn't work well even in the concrete, but especially when I hit rebar. This Bosch bit worked very well - took about 5 minutes for each 6-7" deep hole until the 10th one when I hit rebar dead on. That last one ripped the teeth out of the tip and the bit was done. Bought a second one that went right thru the same piece of rebar.

I previously I wrote a negative review of Bosch's RC2104 Rebar Cutter masonry bit. I decided to upgrade my review to four stars because the bits do work when used correctly. The bits MUST be used on rotation only. Otherwise, the hammering destroys the teeth on the bit. However, the bits do not very last long. Three maybe four cuts through rebar and the bit is shot. Four holes at $28 a bit is expensive cutting in my opinion.