TORRAMI Neoprene Rubber Sheet Roll 1/8 (.125) Inch Thick x 12 Inch Wide x 48 Inch Long for DIY Gaskets, Pads, Seals, Crafts, Flooring,Cushioning of Anti-Vibration, Anti-Slip

Solid material to make gaskets. It’s flexible but strong I hope it lasts!

This is a great rubber backing to use on vinyl Chess mats. It not only lessens the thumping sound of pieces landing on the mat, but also keeps the mat from moving accidentally when sliding the pieces. And, although it’s a little stiffer, it is still easy to roll up for storage or travel. It would have been prefect if they made this material in the size of 24” x 24” x 1/16" square, but using this 12” x 48” x 1/16" works as well.After cutting it in half, I attached the two rubber backings to the back of my vinyl Chess mat as shown using Flex Shot Silicone Rubber and a plastic spatula to spread it around evenly. Then, I allowed the rubber sealant to cure for a full 24 hours where I then used an X-Acto knife to trim the excess rubber at the edges of the mat. Clean up is a little bit of work, but produces great results afterward.

I installed this rubber strip on the door that encloses the engine compartment of our rough terrain forklift. It is one of those doors that goes over the engine compartment and lifts from horizontal to vertical in order to access the engine. When closed, there was a 1/2" gap between the door (or hood if you prefer) and the chassis. I used self tapping screws and went through the rubber into the hood and secured it into place. I did this 6 weeks ago and barely a drop of rain gets through now.This is good rubber that is not either too soft nor too hard. It is just the right consistency at 1/8" for the job it was intended. This is a good product and I would buy it again.

Good rubber. Wish it was reinforced.

I used this to seal the inside of my shed doors and installed with a 90-degree bend. Initially it worked great, no more leaks through the doors (hinge side) during rainstorms. Now the rubber is separating at the fold and is allowing water to seep in. Other applications where it is flat it will probably be stellar.Above was my original review, since then, without any further communication on my part the seller reached out and offered a FULL REFUND! Amazing customer service, most other sellers just move on, these people actually care about their customers! 5+ stars for stellar customer service. although this product did not work in my application, i have others that I will purchase more for from them!

This was bought for a floor in our tripod deer stand and was easy to use. The thickness is just enough and could easily be used for multiple different applications. For the price of the product it's not to bad for what you get. There is no adhesive on the rubber if your wondering but with that said the value for the money is not bad.

I ordered this to use as a rubber spacer between an aluminum deck plate on the steel framerails of my semi truck, just like the factory does. Aluminum and steel don't mix well and need a spacer to prevent corrosion and this worked perfectly. Exactly as described. Plyable yet strong and doesn't tare but is easily cut with razor knife. The is some smell of rubber, but hey, it's rubber and rubber smells. Comes sealed in air tight package that is pretty tough plastic as I couGld not open it with my hands and had to use a razor knife. Glad I found it as the truck dealers I contacted don't carry this in stock. Will work perfect for my need.

I needed solid rubber, but will give spongy neoprene a try. I suspect it will not hold up well, as too much "give" for a pressure seal application. Testing in progress.