Powerbuilt 11 Piece Master Bearing Race and Seal Driver Tool Set, Bearing Press Kit, Seal Installer Bearing Driver Kit for Bearing Installation, Storage Case - 648996

I bought this to do my rear wheel bearings. and it did the job perfectly. I would highly recommend if you need a slide hammer / pull tool to get this one.

Amazing set. Used it for bearing races and seals on my 73 Corvette. High quality and great price.

I needed an odd-sized bearing tool, one that fits a 74 mm diameter bearing. This was the only kit I could find that had it. Much to my surprise, the kit worked very well and had everything needed to make the job go easy. This tool has more available sized bearing discs to fit the non-standard metric (European or Asian) bearings that are out there, which makes it a good value. Though I wasn't sure about what sizes are included in the kit - that info doesn't seem to be listed anywhere - I called AllTrade, which is located in California, and the service people were able to tell me that it had the size tool I needed.The quality of the pieces looks very good. I would expect the parts to hold up just fine. Everything in this kit is black zinc-plated steel, not aluminum as with the less expensive kits. Unlike the other reviewer, the threaded bolt held strong during my job. Make sure if you are using an impact wrench to drive the bolt that the bearing disc is completely pressing on the bearing, and NOT on the knuckle. It can bind up on the knuckle sometimes, in which case I would expect the impact wrench to strip or snap the threaded stud, quality of the part notwithstanding.If you plan to use the bolt and an impact wrench to drive the bearing out instead of a press, make sure you have a 32 mm (impact) socket to turn the main drive nut. I used a Tekton 32 mm impact socket impact bought here on Amazon, and it worked perfectly. The head of the bolt is 28 mm, which I held fast with an adjustable crescent wrench.

Just opened the set. Have not used it yet. But I did pull each piece and every piece looks solid with a decent finish. There is a lot of capability with this set which should meet my needs on my Jeep Wrangler YJ. The case also is solid. This set should provide a lot of great use and pay for itself quickly.

Nice quality and works great! Pulled the axles right out of my 66 mustang convertible with just a couple of slides.

I looked at cheaper sets but most of the other ones looked like much lower quality and were not measured in inch units. Before purchasing this set, I ruined several hub grease seals when repacking my trailer wheel bearings. I tried lightly tapping the seals, used a 2x4 block and several other methods. All fell short and caused more than a little fowl language to slip out! This set is very well made and made the job much easier. Best of all, saves time! I never have enough time... Well packaged and case fits well. There is even built in laminated how too sheets hinged into the case. I highly recommend this set! Worth the money!

If a good old hammer doesn’t knock it loose this certainly will in my experience. I haven’t met a hub assembly or bearing I could get out with it! For the price it’s a nice tool to have around. I would say that I use a towel around the handle and whip it back instead of my hand, while both work you seem to get more leverage or force this way. Best of luck!

I recently received it quickly and was very impressed with it. The slide hammer feels solid and has some decent weight to it. And the components/attachments are also good quality. Sadly, I didn't get to use the slide hammer function to pull the the rear axle from my 99 WJ because after I removed the 4 mounting nuts, I just gave a little tug on the axle hub with my hands and the axle just slid out. That will probably never happen again! But I was able to use the claw components to pull out the bearing race from the axle tube and with ease. I would definitely recommend this axle puller set for pulling axles. I am now just waiting for my front hub bearings to arrive so I can use this to remove the old hub bearings.