WeatherTech Custom BumperTopper for Honda Pilot - Rear Bumper Protector (BP0070) Black

This fits well but is a little expensive for what it is. Adhesion seems very good and it seems like it will provide good protection. But an important not on that: when you first set it, I recommend that you pull a little more of the backing than what they say and then don't press hard until all the backing is removed. For me, the backing tape broke as I was pulling it off, and I almost could not pull the rest of it off because I had pressed half of it and it was pretty tight. But there was just enough backing tape still sticking out such that I could grab it with needle nose pliers and carefully get the rest of the backing off.

Looks great. Easy to put on

Fits perfectly - and easy to install. We had some heavy luggage tumble out of the back on a recent trip that put some dings/chips in the edge of the bumper. The bumper topper covered the dings/chips and will provide further protection to the bumper. Wish I had installed it after purchase. Caution: Be very careful when peeling the plastic off the adhesive backing. Slow and steady and you'll have success.

Fits perfectly. Adhesive is fresh. Weathertech # 1.

Easy to install. Fit perfectly.

It looks great and just looking at it you would think the car came with it! Feels like it's going nowhere. We followed the directions and I don't think it's going anywhere.

It’s the thickest plastic available to protect the bumper. it was difficult to install due to the tape. once the tape cover has been peeled off, you need to apply the bumper protector perfectly and cannot be rearranged/reapplied.it’s a very simple construction and yet very expensive. i took 2 stars off for the price and the difficulty in application.

I read thru previous reviews with potential issues with it lifting up on the end and planned accordingly by adding an additional piece of double sided tape, about 1/5” square on both ends. So far I haven’t had any issues and it feels really secure in all places so it may not of been needed. Install steps are straight forward and simple enough. One note, if you follow the companies instructions for removing the adhesive cover I would make sure you have about 2-3” tabs started. If you pull in a continual motion it removes pretty easily but if not it gets tight in some spots and can tear if you don’t have enough of the tab already available. Quality product. It is a bit pricey, think it should be about $10 less but none the less it is getting the job done so far.