DEWHEL Shifter Cable Bracket Bushings For Ford FOCUS ST & RS 2013-up 6 Speed Manual Transmissions Red

Did this in a 45 min break. I have take the intake side off a few times you will have to move the shifter lines and need 8mm and 10mm and a flat head!

These will work just as good as the more expensive ones. They're solid aluminum donuts. They'll work fine.

The install for me wasn't bad, but I was doing a transmission swap at the time.Honestly, I'm kind of on the fence about these. I did the shift cable ends at the same time. The shifter action is much stiffer, but honestly I feel it's a little too mechanical. Notchy. Shifts definitely take more effort, and you have to pay more attention with your clutch usage and shift action. I don't really feel like any more vibration is passed through the shifter, but you feel every little notch or movement throughout the entire linkage.

These along with aluminum bushings make for a sweet mechanical feel to shifting gears.

Steeda ones fit inside of each other and help square up the bracket by fitting snuggly in the mounting holes as well. These do not. They sit on top of each other and there is a space between them and the bracket so the bracket can move more than with the stock piece.Anyone using super glue to "correct" the problem is really proving the point.Use a little bit of grease if needed but only take out one bolt at a time with the others as loose as you need them to be. You can now move the bracket up to place the bushing under it, then slide the bolt through with the top bushing and bolt already together.

Quality parts. No instructions. Unclamping the shifter cables is a pain if you odnt remove battery and box. Otherwise... Straight forward swap of rubber bushings

Says bracket bushing but sent me cable bushings

Quality finish and material. I used silicone to hold together on install while putting bracket back in. Installed with cable bushings, did take play out of the shifter.