HTTMT MT274-005-SM Turn Signal Lens Compatible with Suzuki Boulevard M50 C50 Vl800 Volusia C90 Intruder M109R Smoke

I purchased these for a 2011 Suzuki Boulevard C50T.As you can see on the photo, they work great!They have a nice smoked look when the bike is off, way better than the stock orange lenses, and they also look great when lit up. I went ahead and replaced my bulbs with LEDs at the same time.I DID have a slight bit of a fitment problem on my bike to be honest. They're NOT the stock housings so the screw didn't quite line up with the hole. It was maybe 1/16th or 1/32nd of an inch too far back from the hole. I used a very tiny drill bit to drill it out by hand.. literally just twisted the drill bit in my fingers to increase the hole a tiny bit and the stock screws went in smoothly. I've done almost 1,000 miles since I put them on and they're doing great.I'd strongly recommend them! I'm gonna try them on the rear lights next!

I bought these for my 06 Suzuki Boulevard C90T, 4 total. On all 4 I had to elongate the hole in the housing so it would line up with the mounting hole on the lens. I just used a 5/32 drill and milled away the material until I could send the screw in. On 2 of them, I had to file down the key so it could rotate into place and lock.Once installed, they looked badass!

Product looks good and has more foam around housing that the factory lens. Also has tight fit in factory housing. However, screw holes that secure it tight are way off. Not even close to lining up. So it's a no go.

Si me agrado lo utilizo para mi moto pero se tardo demasiado en llegar

I like the product it looks nice. However the bike that I bought them for which is listed underneath of the lenses on the website aren’t fitting.The screw hole will not line up where the screw goes in hold the lens on. It’s about a 16th of an inch off. Have to send back, I went back online and looked and can’t find any others than these.

I've purchased a few sets of these and they fit with a little modification. I used thinner screws to allow me to angle in. The two biggest issues I have with these are the darkness of the lens is not consistent and the glue they use gets brittle and fails after some time. I recommend reinforcing the lens with some extra glue before installing.

Work and fit well...super bright with led bulbs...

The only problem I had was that the 'notch' that aligns the lens is slightly too large. With approximately 3 strokes of a small file the problem was solved. Look great and a great value. I recommend these to anyone needing replacements.