Table Inserts for 14" Band Saws or Scroll Saws, Pack of 3

The parts are slightly oversized in diameter (about 15 - 25 mils), but as advertised a little sanding (2 - 3 minutes) brings a perfect fit. Thanks.

Did not fit my saw as claimed. Had to grind it down to fit, it was 1/16 of an inch to big. Well made though

These work great. I did need to remove the paint on the edges so the insert fit.

Got what I paid for but didn't fit JET JWBS-14DXPRO 14". Diameter slightly too large. Had to run it through the disk sander to get it to fit. Throat was also not deep enough for my 3/4" blade so had to modify that as well. In the end, works with modifications.

It says it will fit Grizzly and Ridgid Bandsaws. It won't fit either one. It is about a 1/8" too large.

I have an old harbor freight bandsaw. The insert fits snug and does not move. The original insert was made of plastic.

These fit my Harbor Freight 14" bandsaw fine, but like many others I needed to sand the paint off of the edges of the insert to get it to fit. Took me 2 minutes to do on my belt / disk sander and fit perfect once finished.

Bought these as replacements on my Delta 14" bandsaw. As many others have noted, they tend to be too large (and thick) to fit snugly in the recess. However, I found that by using my stationary sander and rotating the edge of the insert on the sanding surface while it was running, it took no time to trim off the excess material. I also ran the underside edge over the sander and had a perfect fit in less than 5 minutes. The new insert is even better quality than the original. The package of three should last me three lifetimes, but I would order these again if ever needed.