ELECOM Pencil-Feel Screen Protector Designed for Drawing, Compatible with iPad Air 4 (10.9inch, 2020) / iPad Pro 11" 2018/2020 (TB-A18MFLAPLL-W)

This screen protector takes drawing and writing on the iPad Pro to a whole new level, it feels just like paper. Just having the extra friction against the Apple Pencil makes things a lot easier and more comfortable. There is no change to the iPad's behavior or pencil sensitivity either.Its very easy to install, there was only a dry cleaning cloth so if you have stubborn finger prints you may want to buy some screen wipes. The screen protector is very forgiving, so if you make a mistake when trying to install you can remove it and reapply it, just be careful of dust. There is one dust sticker included so this shouldn’t be a problem.For those worried about damaging the Apple Pencil, no doubt this will speed up the degradation of the pencils nibs because of the extra friction but I think it will take a while and the pure enjoyment you’ll have while writing on this is more than worth it.

Fits well, easy to put on and gives a papery feel. Happy with the product.

I haven’t used a Paperlike to compare, but I’m very happy with the result. Nice bit of resistance and the screen clarity isn’t impaired nearly as much as I though it might be.However - installation is TRICKY. Wouldn’t advise if you have a heart condition... here’s a few tips, as somehow I managed to get it on perfectly with no bubbles at all, which seemed like a miracle.- firstly, there are no guide stickers etc like you seem to get with others, you just have to wing it. Clean your screen to perfection, get a bright light on it to pick up every smear and speck of dust. Once you have it clean, odd bits of dust will land as you go, so use the sticker to pick these up as you go.- you have to line the top edge by eye, then unpeel the backing bit by bit as you move across the screen applying as you go. The screen protector seems a fraction smaller than the screen, so bear in mind when initially aligning. You can carefully peel back and keep trying until you are happy the starting bit is as central as you can get it.- SLOWLY work down as the sticker applies. If you see an air bubble gently lift and replace until it’s not there. Also spot check for dust as you do down and remove with the sticker as and when you need. Take your time, and clean your screen thoroughly, and you’ll get it on perfectly.- be gentle when peeling back the final protective layer as it will want to pull the protector away with it. Once you get going with it, it will come away easy.Hopefully this will help someone, I’m still amazed it went on perfectly but the key is patience and lots of light.The screen itself feels nice, not too scratchy - enough resistance to gain control of your lines without feeling too coarse. And reasonably priced.

Superb. I’ve wasted money on four from Paperlike and every single one was been a poor install with bubbles. Total waste of money. This one, on first time, bubble free. Delighted.

Incredible product, really does look good and is very easy to install. Applied with a few bubbles but they squeeze out easily.

I'm using it for the past days and it feels really nice to the pen touch.

Maybe i was lucky but this was very easy to install... zero bubbles etc.Others at the same price point were a nightmare!

What a load of crap. Doesn’t come with anything to clean the screen bar one tiny scrap of cloth that doesn’t even wrap around a finger, no alcohol wipe or anything. A bit ridiculous when even the smallest particle ruins the whole screen. Went in the bin.