Replacement Part ZR Button Key Ribbon Flex Cable for Nintendo Switch Joy Con Controller

The replacement worked without any issues.

I thought I wasn’t going to fix my joy con after breaking the original during a shell swap. This fit and worked perfectly and saved my from needing to throw away my original joy on.

I’ve bought quite a few replacement triggers and most of them lack the same feel or sound as the original part. Usually they require quite a bit more pressure to activate or they sound way too loud compared to OEM, making it difficult to get used, especially if you don’t change out both joycon’s triggers.These however are as close to OEM as I have found. They feel EXACTLY like the original part. They have the exact same resistance when pressed. They even sound relatively close as well, though there is a difference if you are listening close enough.All in all though, this is your best shot in terms of replicating the original feel of the triggers.

This installed exactly the way the YouTube videos said it would, and it has been working perfectly after several dozen hours of use. Just make sure you know what you're doing and that you have the proper tools to open up your Switch controller.

Fixes my problem

Get some helping hands to hold the ribbon and youll be good!

I was very happy that I found these since having a bad experience from buying from another seller. These sound and the pressure needed to press down the button is the same as the OEM. There are others that sound so very loud and very hard to press the button down making it impossible to use but not these. These are the close to OEM and the only difference to the original ZR button that I was replacing was the traces were slightly run different but other than that it is the same and functions as so. I am very happy with these. I would highly recommend.::HIGHLIGHTS:: Button pressure/weight is the same. Sound is not louder and it sounds almost like OEM. Might be slightly more expensive from others but again it is worth it knowing there is no difference to OEM.

(This one did come with the needed screw drivers, I don't know why they are not listed or shown in the pictures) Looks almost identical to the original. But requires tons of calm and time to intsall. Its very small and that's makes it hard to hold on to with out small tools. Wish it came with rubber tipped tweezers, but the part was under $8.Removing the ZR button is what broke the circuit board button, so be very careful.