Minwax Helmsman Indoor/Outdoor Spar Urethane, Quart, Gloss

I have an east facing door that gets beat on by the sun for couple of hours every day. The original finish cooked right off and started splitting the wood. I sanded the door back down to raw wood, filled in the splits, re-stained with a Minwax stain, then followed up with 3 coats of Helmsman Spar Urethane. It was tedious to do at first because it was a lot of work to get the door back to raw wood and you have to wait 4 hours and sand in between coats. Now that it's done, it's never worn through the 3 coats. Annually I use a red scotch bright sanding pad and lightly re-sand, add a coat, wait 4 hours and re-sand, then another coat. It's much faster now that I'm just adding coats and using a scotch bright sanding pad to refinish the urethane. Less than 30 min to sand and re-coat each layer. Use a good quality brush like a Purdy. I used a cheaper brush in the past and it left brush strokes in the finish. Clean with mineral spirits. I liked it so much I ended up doing the same finish on my east/west facing wood gate that gets sun all day long and it holds up great.

Can holds generous amount. Applies evenly

Product is as advertised and worked great! I highly recommend! Water based easy to rinse brushes off

Great finish with new spray pattern perfecto

I used this for outdoor "yard art", specifically a few metal signs and then several wood signs our family painted. This sprays in a nice, uniform spray and covered very well. Of course part of that is technic so it doesn't pool and run. Still, gives a nice looks with protection. I've used this before and it will, over time and especially in the sun start to peel a bit, but I think it works well for my projects.

Want a long-lasting wood protector? This is it.

Went on easy, looks good. Wouldn't expect anything less from Minwax.

Great Product