X AUTOHAUX3pcs Turbocharger Actuator Wastegate Circlip E Clip Pin for Garrett T2 T25 T28

Great value

for turbo actuator On 2011 Mercedes sprinter

Product arrived on time and was an exact fit for our Chevy Cruze.

I cannot speak for the longevity but the product fits as expected.

If you've disassembled a turbo to clean the vanes, or to adjust the actuator rod, you know that this little piece will go flying across the garage and get lost in the black hole. Have these on hand.I have a 2002 VW TDI with a VNT turbo. It's a hybrid 17/22, but would work for the VNT 15 and VNT 17 as well.The description is a bit misleading and says these are plastic, but they are in fact steel clips

This is exactly what I needed to securely attach the waste gate valve to the turbo on my 2016 Chevy Cruze Limited. The factory clip apparently came loose and popped off, creating a "service engine soon" dash light.When I looked up the DTC (trouble code PO299), it said low output boost on the turbo. Noticed the waste gate rod was not connected to the turbo. Ordered this clip (3/package), snapped one back on, and it's been holding for the last 10k miles flawlessly.Seems well made and it's doing the job it needs to.

Cheap material easy bent

Update. Downgrading my review as I've now lost two of these and am on the last one. The first one lasted about a month so when I lost it I chalked it upto too many installation and removal attempts then the second one only lasted one short drive then it was gone.It's not a 1 star item but I finally paid extra attention on the third clip and noticed that if you push it on the wga too far it actually opens up at the furthest position if you squeeze it too tight, but if you gently push it on until the first hump it appears to be on... For now.... At least until my oem replacement gets here.Don't recommend it, as if you lose your clip and put your heat shield back on you could have the wga arm fall off and lose all of your boost at anytime which is a safety issue as well as an annoyance if you press the gas and expect a certain amount of power and have barely enough to get out of your own way.Fits the gm LUV/LUJ 1.4t engine such as cruze, sonic, Trax. It's not quite as snug of a fit or as thick as the oem gm clip but it's working fine so far and you get three so much better if you are going to be taking it on or off alot as they are easy to get swallowed by the engine even if you are careful. I have been making adjustments to my aftermarket wga to dial in my tune so I have been removing it alot.