GXARTS Driver or Passenger Side Bottom Replacement Leather Seat Cover Black Compatible with Chevy Avalanche Silverado Suburban Tahoe GMC Sierra Yukon 2007 2008 2009 2010 2012 2013 2014

This might be the best product I have purchased in a long time. Replaced original seat covers upper and lower on my 2011 Chevy Silverado. The fit and color are awesome. Take your time, remove the seat and do it right. The wrinkles take a few days to work themselves out, especially on my upper portion, but my truck looks amazing. The only thing missing were instructions. Watch a couple videos and become a pro. This was my first time trying this and the outcome even surprised me. Hint: Don't simply rip off the old cover or you will rip out the clips that are embedded in the foam cushion. I will be buying another set right away for another truck I own.

I have been looking for this product for a long time! I have tried lots of different remedies for the cracks in the seats, including looking into getting the seat recovered, which was very expensive. This provided an excellent option at a very reasonable cost! I would highly recommend this product! The fit was absolutely perfect and looks outstanding. Extremely comfortable and very high-quality. Takes a little bit longer to install, but it is worth it!

I had a rip on the outside edge of my Silverado drivers seat. Ordered this hoping it would match well with the color and fit properly. It did not disappoint. It probably would of went on a little easier if the material was warm like in the summer. I did it in December so the material was colder but after about 30 minutes I was happy with the install. Be aware that if you have power seats you will have to cut out for the seat switches. Its no big deal but measure twice and cut once. I used a utility knife and it turned out fine. Overall the cover fits basically like a glove and not a bad job to install it.

Not bad , just a little different design

Pretty easy to install. The color matches perfectly. Would buy again

Fits perfectly looks just as it did from the factory

1st impressions are great. Matches factory seat cover to a T minus a few missing holes you need to make. I used a soldering iron to make said holes on the side and 2 in the back for the clips to go through. Because if you cut it then it'll more than likely spread hence the reason for using soldering iron. Tools you need is 7mm for tiny screw holding cover on up front. Then you need a 9/16 for the front two nuts and 7/16 for the back to bolts. It's a straight forward job and can be done with some time if you haven't pulled seats before. From start to finish took me about 45mins. Hope this helps some people on if they want to do this or not. Only time will tell about longevity of the product.

NOT LEATHER! Advertised as leather, it is NOT! It is a very nice piece but not leather as it is advertised.

It was easy to install and the fit is good.

color was a bit darker than original but looks good softer material than original

In the picture it looks original leather but what you get in not leather at all. They need to change the advertising on this to fake leather and charge less too

Not exactly as Oem. looking good, install easy, very soft, not OEM durability. very good buy for the money.