Question 1

how long to charge this energizer aaa battery with my eastshine s2 charger? can be charged at 1000amp? the battery will be hot?

Accepted Answer

The charger must be listed to work with the specific chemistry. If your charger says it will charge NiMH (nickel - metal hydride) batteries is should be good. Remove the battery from the charger when fully charged. The battery may be warm when the charge ends; this is normal because of the work (energy transfer) that has been done. In general batteries should be charged at 1/10 their normal discharge rate listed on their specification sheet (usually available online from the manufacturer.) If you are making you own charger, note that newer chemistries such as NiMH require use of an electronic charge management circuit and temperature sensor to vary the charge rate to prevent overheating the battery. (These are available online.)

Question 2

can you use these in a cordless phone

Accepted Answer

yes you can. i prefer the rechargeable saves money and most of time the rechargeable that came with phones are not as good as these here. we use a panasonic   branded cordless phones and  replaced them with these. no issues from batteries. even if your original batteries are non rechargeable these should work. But keep in mind there are phones that use another style of batteries so one must check your phone and see.

Question 3

What is the actual maH of the batteries that I will recieve?

Accepted Answer

The specs say 700maH

Question 4

What would be the recommended recharge cycle to optimize these batteries (AAA). *using a charger with adjustable settings

Accepted Answer

Using up to 400mAh (500mAh might be fine but the batteries will be a bit warmer) in a smart charger and usually i will refresh the batteries in a high drain device (or the device you plan on using them in). If the device is not a high drain device such as a USB battery pack or a Maglite flashlight (you'd have to monitor the flashlight to avoid over discharging) then using a smart charger with a discharge feature is the best way.You shouldn't need to cycle the batteries more than once (top off charge > discharge > full recharge), you could actually test the batteries and that would be good enough, i suggested the latter though because i don't want to waste cycles on a smart charger. One full discharge cycle upon purchase is necessary due to self discharge and most likely because the batteries are more than a few months old and then subsequent refreshing is only needed based on usage. The more you recharge them the more you refresh them, but is generally a good idea to regularly charge them if you are using them daily.

Manufacturer	Energizer Batteries
Item model number	EVENH12BP4
Product Dimensions	9.4 x 11.43 x 1.27 cm; 40 g
ASIN	B000BESLQK

Energizer EVENH12BP4 Recharge Power Plus AAA 700 mAh Rechargeable Batteries, Pre-Charged, 4 Count

Details

Description

Specifications

Have a Question? See What Others Asked

Common Questions