HSP 02060 Blue VX18 Engine 2.74cc Pull Starter for RC 1/10 Nitro Car Buggy

Can’t say this for everyone-my engine came clean and felt smooth -I always disassemble, inspect, also cleaned up some casting areas I didn’t like -only issue…first head bolt wasn’t torqued - I’ve had good luck with this little cheap engine in the past -HSP .18 10th scale all aluminum modified street buggy -nice thing is the engine doesn’t kill parts -just enough power to have fun with-

Great little engine! It has been one of the most reliable and consistent nitro engine I've run. With an OS #8 plug and 20% nitro, and a slightly rich needle the engine will idle reliably day long and packs a pretty good punch for its size. Great little engine

The motor looks really good and it fired up right away and got good power and sounds vary healthy

This thing is...slow, slower than the original osmax .12 engine that was in the stadium truck. It works, but there is just NO torque, compression is iffy, seal of the head is somewhat poor. I did do the standard 5 tank break in of idle, idle-20%, 35% max, 50% max, 75% then a post break in tank allowing short 100% runs on the straight but no jumping. It also runs pretty hot (peaks of 140c) even when real rich on medium heat glowplugsI wish it had been better, but it is what it is. If you're curious it's running an RC10GT I rebuilt, but as soon as funds will allow I'll be buying a new sleeve for the old engine (if I can find one).

Runs great

this engine's badass I put it in my rs4 3 it's really fast I didn't break it in properly I just put it in a gunned it and it responded also extremely easy to tune start from a rich setting lean er out

The media could not be loaded. Needed a new engine for my dirt buggy. Worked great!

This engine doesn’t work.